Frelander 2. Manual — part 678
6.
Repeat the above procedure on the opposite hand.
7.
8.
Repeat the above procedure on the opposite hand.
9.
10.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
10.
Remove both rear wheels and tires.
Refer to:
Wheel and Tire
(204-04 Wheels and Tires, Removal and
Installation).
11.
If installed, remove the rear suspension height sensor.
Refer to:
Rear Suspension Height Sensor
(204-05 Vehicle Dynamic
Suspension, Removal and Installation).
12.
Remove the rear muffler.
Refer to:
Exhaust System
(309-00B Exhaust System - TD4 2.2L
Diesel, Removal and Installation).
13.
14. CAUTIONS:
Mark the position of the driveshaft flange in
relation to the drive pinion flange.
To avoid damage to the joint or gaiter, do not
allow the driveshaft to hang.
Discard the bolts.
14.
15.
Repeat the above procedure on the opposite hand.
16.
17.
18.
Repeat the above procedure on the opposite hand.
19.
20.
CAUTION: Make sure that no load is placed on
the brake hose.
Tie the rear brake caliper aside.
20.
Repeat the above procedure on the opposite hand.
21.
22.
CAUTION: Make sure the bushing(s) or
isolator(s), are not strained or left unsupported during
this procedure.
Release the trailing arm to body bracket.
22.
Repeat the above procedure on the opposite hand.
23.
Support the subframe.
General Equipment:
Powertrain Jack
24.
25.
Carefully lower the subframe for access to the differential breather
lines.
26.
27.
28.
CAUTION: Make sure that no components catch.
With assistance, remove the rear subframe assembly.
28.
29. NOTE: Do not disassemble further if the component
is removed for access only.
29.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст