Frelander 2. Manual — part 677
1.
CAUTION: Make sure that the component aligns
with the installation mark.
Install the bushing.
Special Tool(s):
204-598
,
204-598-01
1.
Install the front subframe.
Refer to:
Front Subframe
(502-00 Uni-Body, Subframe and Mounting
System, Removal and Installation).
2.
Connect the battery ground cable and install the cover.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
3.
Uni-Body, Subframe and Mounting System - Front Subframe Rear Bushing
Removal and Installation
Special Tool(s)
204-598
Hydraulic Cylinder 10t
204-598-01
Remover/Installer, Subframe Bushing Guide
Removal
Remove the cover and disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
2.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
2.
Remove the front subframe assembly.
Refer to:
Front Subframe
(502-00 Uni-Body, Subframe and Mounting
System, Removal and Installation).
3.
4.
CAUTION: Mark the components to aid
installation.
Special tool 204-598-01/8 is used to start the
bushing removal process, and must be removed
after the bushing has released, as it will not
pass through the sub-frame bushing aperture.
Remove the bushing.
Special Tool(s):
204-598
,
204-598-01
4.
Installation
1.
CAUTION: Make sure that the component aligns
with the installation mark.
Install the bushing.
Special Tool(s):
204-598
,
204-598-01
1.
Install the front subframe.
Refer to:
Front Subframe
(502-00 Uni-Body, Subframe and Mounting
System, Removal and Installation).
2.
Connect the battery ground cable and install the cover.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
3.
Uni-Body, Subframe and Mounting System - Rear Subframe
Removal and Installation
General Equipment
Powertrain Jack
Removal
1.
Remove the stowage compartment.
2.
3. NOTE: Use an additional wrench to prevent the component from
rotating.
Remove the adjusting nut and disconnect the front parking brake
cable.
3.
Release the rear parking brake cables and remove the
compensator.
4.
Remove the rear quarter trim panels.
Refer to:
Rear Quarter Trim Panel
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
5.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст