Frelander 2. Manual — part 126
Anti-Lock Control - Anti-Lock Brake System (ABS) Module
Removal and Installation
Removal
• CAUTIONS:
Extreme cleanliness must be exercised when handling these components.
If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.
All vehicles
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
2.
Remove the battery tray.
Refer to:
Battery Tray
(414-01 Battery, Mounting and Cables,
Removal and Installation).
3.
Right-hand drive vehicles
Remove the plenum chamber panel.
4.
Left-hand drive vehicles
Remove the windshield wiper motor and linkage.
Refer to:
Windshield Wiper Motor
(501-16 W ipers and Washers,
Removal and Installation).
5.
6.
CAUTION: Make sure that all openings are
sealed.
6.
All vehicles
7.
8.
9.
Left-hand drive vehicles
10. CAUTIONS:
Be prepared to collect escaping fluids.
Make sure that all openings are sealed.
10.
Right-hand drive vehicles
11. CAUTIONS:
Be prepared to collect escaping fluids.
Make sure that all openings are sealed.
11.
All vehicles
12. CAUTIONS:
Be prepared to collect escaping fluids.
Make sure that all openings are sealed.
12.
Installation
All vehicles
Install the ABS module.
Torque: 10 Nm
1.
Install the brake fluid tubes.
Torque: 15 Nm
2.
Install the battery tray support.
Torque:
M6 10 Nm
M8 25 Nm
3.
Left-hand drive vehicles
Connect the brake booster vacuum line.
4.
All vehicles
Install the ECM.
5. Secure the vacuum line and harness.
6.
Left-hand drive vehicles
Install the windshield wiper motor and linkage.
Refer to:
Windshield Wiper Motor
(501-16 W ipers and Washers,
Removal and Installation).
7.
Right-hand drive vehicles
Install the plenum chamber panel.
8.
All vehicles
Install the battery tray.
Refer to:
Battery Tray
(414-01 Battery, Mounting and Cables,
Removal and Installation).
9.
Connect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
10.
Bleed the brake system.
Refer to:
Brake System Bleeding
(206-00 Brake System - General
Information, General Procedures).
11.
If a new component has been installed, configure using Land Rover
approved diagnostic equipment.
12.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст