Defender. Manual — part 252
Rear View Mirrors - Interior Mirror
Removal and Installation
Removal
1. Prise interior mirror arm from mounting plate.
2. Remove 3 screws and remove mounting plate from
headlining.
Installation
1. Install mounting plate to headlining.
2. Locate lower lug of mirror arm in mounting plate aperture.
3. Press mirror arm firmly to engage the spring clip.
Seating -
Torque Specifications
Description
Nm
lb-ft
Rear seat base stop bolt
23
17
Rear seat bolts
23
17
Rear seat nuts
23
17
+ Front seat backrest nuts and bolts
23
17
Front seat bolts
23
17
Third row seat bolts
23
17
Third row seat nuts
23
17
Third row seat nut and bolt
23
17
+ New nuts must be installed
Seating - Seats
Description and Operation
COMPONENT LOCATION
OVERVIEW
Vehicles from 2007 model year are fitted with an all new seating system. The front seats are manually adjustable for
reach and recline. Some vehicles may also feature heated front seats. The heated front seats will only operate when the
ignition is switched on.
The second row seats feature a 60/40 split and are able to be folded forward to increase the loadspace in the rear of the
vehicle. Defender 110 Station Wagons are fitted with 2 forward facing third row seats. The third row seats can be
stowed at the side of the cabin to increase the loadspace in the rear of the vehicle. For more information on seat
stowage, refer to the Owners Handbook.
PRINCIPLES OF OPERATION
Heated Front Seats
When the ignition switch is in position II (ignition on) a feed is provided to the window lift relay coil via the central
junction box (CJB). The ground path for the relay coil is controlled by the left-hand (LH) and right-hand (RH) heated
seat switches. When either switch is pressed, the relay energizes and provides a battery voltage feed to the appropriate
seat heater elements. Both seats contain 2 heating elements; 1 in the cushion, 1 in the backrest, which are wired in
series.
The cushion elements in both front seats contain a thermostatically controlled switch. When the cushion element
temperature reaches 37 ± 3°C (98 ± 3°F) the thermostat cuts the supply to both the cushion and backrest elements.
When the temperature of the cushion element falls below 28 ± 3°C (82 ± 3°F) the thermostat reinstates the supply to
both heater elements.
Seating - Front Seat
Removal and Installation
Removal
1. Remove the front seat cushion.
For additional information, refer to:
Front Seat Cushion
(501-
10 Seating, Removal and Installation).
2. Remove the front 2 bolts from the front seat.
Disconnect the front seat heater mat electrical
connector.
3. Remove the front seat.
Slide the front seat forwards.
Remove the 2 bolts.
Collect the 8 spacer washers.
Installation
1. To install, reverse the removal procedure.
Tighten the bolts to 23 Nm (17 lb.ft).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст