Range Rover Classic. Manual — part 114
REAR SUSPENSION
5
REPAIR
Renew bush
7. Press out rubber bushes.
8. Fit bush centrally in housing.
CAUTION: Apply pressure to outer edge of
bush, and not rubber inner.
Refit
9. Reverse removal procedure. 1 to 6. Do not fully
tighten fixings until all components are in
position.
10. Tighten fixings to correct torque.
See
Specifications, torque, Torque Values
SUSPENSION LINK LOWER
Service repair no - 64.35.02
WARNING: Air suspension vehicles:
Depressurise system before commencing
work.
See AIR SUSPENSION, Adjustment,
Depressurise System
Remove
1. Site vehicle on a ramp [hoist].
2. Alternatively, support vehicle on stands under
rear axle.
3. Remove rear fixings.
4. Remove mounting bracket fixings at side
member bracket.
5. Remove lower link complete.
6. Remove locknut.
7. Remove mounting bracket from lower link.
64
REAR SUSPENSION
6
REPAIR
Renew bush
8. Press out rubber bushes.
9. Fit bush centrally in housing.
CAUTION: Apply pressure to outer edge of
bush, and not rubber inner.
Refit
10. Reverse removal procedure. 6 and 7. Do not
tighten locknut.
11. Reverse removal procedure. 3 to 5.
12. Lower vehicle, allow axle to take up static laden
position. Tighten to
175Nm
NOTE: Air suspension vehicles:
Repressurise system
REAR SUSPENSION
7
REPAIR
ANTI-ROLL BAR REAR
Service repair no - 64.35.08
KEY
1. Anti-roll[sway] bar
2. Rubber bush
3. Strap
4. Nut, bolt, washer
5. Nut and washer
6. Ball joint link arm
7. Bolt and washer
8. Castellated nut and cotter pin
Remove
1. Note for reassembly, position of rubber bushes
on anti-roll[sway] bar.
2. Remove four nuts, bolts and washers securing
two bush straps.
3. Remove nuts, bolts, washers and rubber bushes
from the ball joint links and remove
anti-roll[sway] bar.
Refit
4. Position rubber bushes on anti-roll[sway] bar. Fit
joint in bush towards axle.
5. Fit anti-roll[sway] bar with two straps. Ensure ball
joint link arms point down as shown. Loosely fit,
bolts, washers and new Nyloc nuts.
6. Fit bolt, washers and rubber bushes. Fit
anti-roll[sway] bar to ball joint links. Tighten to
68Nm
7. Tighten nuts securing straps to
30Nm.
64
REAR SUSPENSION
8
REPAIR
ANTI-ROLL BAR BALL JOINT LINKS
Service repair no - 64.35.24
Remove
1. Remove two nuts, bolts, washers and rubber
bushes from ball joint links and lower
anti-roll[sway] bar to clear links.
2. Remove cotter pin and loosen castellated nut a
few turns.
3. Release ball joint using special tool 18G 1063A
as shown.
4. Remove castellated nut and ball joint link.
Refit
5. Fit ball joint link arm and castellated nut. Point
ball joint link arm down as shown. Tighten to
40Nm and fit new cotter pin.
6. Align anti-roll[sway] bar to ball joint links.
7. Fit bolts, washers and rubber bushes using new
self locking nuts secure anti-roll[sway] bar to ball
joint links. Tighten to
68Nm.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст