Freelander Body Repair Manual — part 38
BODY
16
EXTERIOR FITTINGS
Refit
1. Fit fasteners to arch extension.
2. Fit wheel arch extension to studs.
3. Fit scrivets securing extension to wheel arch.
4. Fit road wheel(s) and tighten nuts to correct
torque.
See INFORMATION, Torque wrench
settings.
5. Remove stand(s) and lower vehicle.
GRILLE - FRONT
Service repair no - 76.55.03
Remove
1. Remove 4 screws from grille.
2. Release 2 catches securing bottom of grille.
3. Remove grille.
Refit
1. Position grille to body, locate with securing
catches.
2. Fit and tighten screws.
BODY
EXTERIOR FITTINGS
17
VENT - REAR QUARTER
Service repair no - 76.81.24
Remove
1. Remove 2 Torx screws securing vent hinge
covers.
2. Remove covers from hinges.
3. Remove 2 screws securing hinges to vent.
4. Remove hinges from vent.
5. Remove nuts from vent and discard sealing
washers.
6. With assistance remove screw securing vent
catch to body.
7. Remove vent.
8. Remove screw securing catch to vent.
9. Remove catch from vent.
10. Remove nut from vent and discard sealing
washers.
Refit
1. Fit nut and NEW sealing washer to vent.
2. Fit catch and tighten screw.
3. With assistance fit vent and tighten catch
screw.
4. Using NEW sealing washers fit nuts and
hinges to vent. Fit and tighten hinge screws to
vent.
5. Fit hinge covers and tighten Torx screws.
BODY
INTERIOR TRIM COMPONENTS
1
SUN VISOR
Service repair no - 76.10.47
Remove
1. Release sun visor from retaining clip.
2. Remove 2 screws securing sun visor.
3. Remove sun visor.
Refit
1. Fit sun visor and secure with screws.
2. Secure sun visor in clip.
FINISHER - ’A’ POST
Service repair no - 76.13.07
Remove
1. Release seal from door aperture.
2. Release 4 clips and remove ’A’ post finisher.
3. Remove clips from finisher.
Refit
1. Fit clips to ’A’ post finisher.
2. Fit finisher to ’A’ post and secure with clips.
3. Fit seal to door aperture.
BODY
2
INTERIOR TRIM COMPONENTS
CASING - REAR QUARTER LOWER - 3 DOOR
Service repair no - 76.13.12
Remove
1. Release rear seat squab and fold seat forward.
2. Release load space lamp from trim casing.
3. Disconnect 2 Lucars and remove load space
lamp.
4. Remove 6 Torx screws securing luggage
compartment carpet retainer.
5. Remove carpet retainer.
6. Release 4 turn buckles securing trim casing.
7. Release and remove trim casing from luggage
compartment.
Refit
1. Position casing in luggage compartment.
2. Fit turn buckles
3. Fit luggage compartment carpet retainer and fit
Torx screws.
4. Position load space lamp to casing, connect
Lucars and secure lamp in casing.
5. Reposition rear seat.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст