Freelander Body Repair Manual — part 43
BODY
INTERIOR TRIM COMPONENTS
19
GLOVE BOX
Service repair no - 76.52.03
Remove
1. Open glove box lid.
2. Release illumination lamp from glove box.
3. Remove 4 screws and remove glove box.
Refit
1. Position glove box and tighten screws.
2. Position and secure illumination lamp.
3. Close glove box lid.
HEADLINING - 5 DOOR
Service repair no - 76.64.01
Service repair no - 76.64.15
Remove
1. Remove both A’ post trims.
See this section.
2. Remove both rear quarter upper trim casings.
See this section.
3. Remove both sun visors.
See this section.
4. Remove screw from each sun visor clip and
collect clips.
5. Remove screw covers and screws from grab
handles and remove grab handles.
6. Remove grab handle blanking plugs.
BODY
20
INTERIOR TRIM COMPONENTS
7. Release roof lamps, disconnect multiplugs and
remove roof lamps.
8. Release both B/C’ post upper finishers and
position aside.
9. Release headlining from front and rear door
aperture seals.
Models with sun roof:
10. Release and remove sun roof surround finisher
from sunroof aperture.
All models:
11. Remove 5 retaining studs from headlining.
12. With assistance remove headlining through tail
door.
BODY
INTERIOR TRIM COMPONENTS
21
Do not carry out further dismantling if
component is removed for access only.
13. Release 8 tags securing front roof lamp
support and remove support.
14. Remove 14 nuts from stowage pockets, collect
backing plates and remove stowage pockets.
15. Position stowage pockets and backing plates
on replacement headlining and secure with
nuts.
16. Position roof lamp support on replacement
headlining and secure retaining tags.
Refit
1. With assistance, position headlining and
secure with retaining studs.
Models with sun roof:
2. Position sunroof surround finisher and secure
in position.
All models:
3. Locate headlining to front and rear door
aperture seals.
4. Fit and secure ’B/C’ post upper finishers.
5. Connect multiplugs and fit roof lamps.
6. Fit grab handle blanking plugs.
7. Fit grab handles, tighten screws and fit screw
covers.
8. Fit sun visor clips and tighten screws.
9. Fit both sun visors.
See this section.
10. Fit both ’A’ post trims.
See this section.
11. Fit rear quarter upper trim casings.
See this
section.
BODY
22
INTERIOR TRIM COMPONENTS
HEADLINING - 3 DOOR
Service repair no - 76.64.15
Remove
1. Fold front seat squabs forward.
2. Remove both sun visors.
See this section.
3. Remove both ’A’ post trims.
See this section.
4. Remove 2 screws from both sun visor clips and
collect clips.
5. Remove 2 screws securing headlining to front
end of roof panel.
6. Remove roof lamp lens.
7. Remove 2 screws, release roof lamp and
disconnect multiplug.
8. Release headlining rear finisher from roof
panel and remove finisher.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст