Jeep Grand Cherokee WK. Manual — part 1610
21. Install the two nuts (1) on the studs (2) above the
column tighten the nuts to 12 N·m (105 in. lbs.).
22. Connect the two left bulk connectors.
23. Connect the two fuse block connectors.
23 - 98
INSTRUMENT PANEL
WK
24. Connect the white connector to adjustable brake
pedal.
25. Install the grounds within the steering column
opening and install the bolts.
26. Install the left cowl trim panel (1) and install the
nut (2).
WK
INSTRUMENT PANEL
23 - 99
27. Install the left door sill.
28. Install the column cross bolt (1) and tighten to 12
N·m (105 in. lbs.).
29. Position the steering column shaft into the slip
joint.
30. Lift the column into position and install the bolts
(1).
31. Tighten the bolts to 12 N·m (105 in. lbs.).
32. Slide the coupler onto the column shaft and install
a new coupler bolt (2). Tighten the coupler bolt to
49 N·m (36 ft. lbs.).
23 - 100
INSTRUMENT PANEL
WK
33. Connect the shifter cable and electrical connec-
tors to the ignition.
34. Install the ignition cylinder (1) and install the
screws (2).
35. Position the ignition bezel and seat fully.
36. Connect the electrical connector (3) for the multi-
function switch (2).
37. Install the upper shroud (1) on the column.
38. Install the lower shroud (2) to the column.
39. Snap the two halves back into place.
40. Install the three mounting bolts to secure the
shroud in place.
WK
INSTRUMENT PANEL
23 - 101
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст