Jeep Grand Cherokee WK. Manual — part 1252
CROSSMEMBER-ENGINE CRADLE
REMOVAL
1. Support engine using engine support tool #8534 or
equivalent.
2. Remove the front skid plates. (Refer to 13 -
FRAME
&
BUMPERS/FRAME/SKID
PLATE-
FRONT - REMOVAL)
3. Remove the rotors. (Refer to 5 - BRAKES/HY-
DRAULIC/MECHANICAL/REMOVAL
-
FRONT
DISC BRAKE ROTOR)
NOTE: Do not twist the boot anytime during
removal or installation.
4. Remove the outer tie rod end (2) nut (1) from the
ball stud.
5. Separate the outer tie rod end (3) from the knuckle
with Remover 8677 (5).
13 - 24
FRAME & BUMPERS
WK
6. Remove the upper ball joint nut.
7. Separate the upper ball joint (2) from the knuckle
(3) using tool 8677 (1).
8. Remove the axle nuts and reinstall a couple
threads.
9. Disconnect the speed sensors (2) and separate the
harness from the support clips (1).
WK
FRAME & BUMPERS
13 - 25
10. Remove the lower ball joint nut.
11. Separate the lower ball joint from the knuckle (1)
using tool C–4150A (2).
12. Remove the axle nuts (3) and remove the knuck-
les (1) from the vehicle.
13. Remove the lower clevis bolts.
13 - 26
FRAME & BUMPERS
WK
On 4WD models:
1. Disconnect the electrical connector(1) (if equipped)
and the vent hose (2).
2. Remove the right half shaft.
3. Separate the propeller shaft as necessary, and
position out of the way. (Refer to 3 - DIFFEREN-
TIAL &
DRIVELINE/PROPELLER
SHAFT/PRO-
PELLER SHAFT-FRONT - REMOVAL)
4. Drain the differential.
5. Support the differential with a suitable lifting device.
6. Remove the front differential front bolts.
7. Remove the differential right bolt.
WK
FRAME & BUMPERS
13 - 27
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст