Jeep Grand Cherokee WK. Manual — part 1253
8. Remove the differential rear bolt.
9. Remove the differential assembly with the left half
shaft still attached.
14. Loosen the engine mount bolts.
15. Raise the engine so that the weight is off of the
mount bolts.
13 - 28
FRAME & BUMPERS
WK
16. Secure the steering wheel in the straight ahead
position.
17. Remove the steering gear as necessary. (Refer to
19 - STEERING/GEAR - REMOVAL)
18. Support the cradle with suitable lifting device.
19. Using a grease pencil or equivalent, mark the
location of the engine support cradle on the
underbody.
20. Remove the four bolts at each corner and lower
the cradle.
21. Remove the lower control arms.
22. Remove the sway bar.
INSTALLATION
1. Install the sway bar onto the engine cradle as nec-
essary. (Refer to 2 - SUSPENSION/FRONT/STABI-
LIZER BAR - INSTALLATION)
2. Install the lower control arms as necessary. (Refer
to 2 - SUSPENSION/FRONT/LOWER CONTROL
ARM - INSTALLATION)
3. Raise the engine cradle into position guiding the
engine mount bolts into the engine cradle slots.
4. Install the four engine cradle bolts (1 & 2).
5. Align the engine cradle to the marks made during
removal and tighten the front bolts (1) to 203 N·m
(150 ft. lbs.).
6. Tighten the rear bolts (2) to 122 N·m (90 ft. lbs.).
7. Install the steering gear as necessary. (Refer to 19
- STEERING/GEAR - INSTALLATION)
8. Lower the engine fully onto the engine mounts.
WK
FRAME & BUMPERS
13 - 29
9. Tighten the engine mount bolts to 111 N·m (82 ft.
lbs.).
On 4WD models:
1. Position the front differential into the vehicle and
install the bolts.
2. Tighten the rear bolt to 102 N·m (75 ft. lbs.).
13 - 30
FRAME & BUMPERS
WK
3. Tighten the right differential bolt to 102 N·m (75 ft.
lbs.).
4. Tighten the front differential front bolts to 54 N·m
(40 ft. lbs.).
5. Install the propeller shaft as necessary. (Refer to 3
-
DIFFERENTIAL
&
DRIVELINE/PROPELLER
SHAFT/PROPELLER SHAFT - INSTALLATION)
6. Install the right half shaft onto the differential.
7. Connect the electrical connector (1) (if equipped)
and the vent hose (2).
WK
FRAME & BUMPERS
13 - 31
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст