Jeep Liberty KJ. Manual — part 939
REAR FASCIA
REMOVAL
1. Remove the wheel flares (rear) (Refer to 23 -
BODY/EXTERIOR/REAR
WHEEL
OPENING
FLARE MOLDINGS - REMOVAL).
2. Remove the rear lamp units (Refer to 8 - ELEC-
TRICAL/LAMPS/LIGHTING
-
EXTERIOR/REAR
LAMP UNIT - REMOVAL).
3. Remove the four side bolts.
4. Remove the two bottom rivets.
5. Remove the 3 screws along the upper edge.
6. Separate the side plastic retainers and remove the
fascia from the vehicle.
13 - 4
FRAME & BUMPERS
KJ
INSTALLATION
NOTE: Fascia must be pushed completely forward
to allow the plastic retainers full engagement in
their respective slots.
1. Install the fascia and insert the plastic retainers.
2. Install the three upper screws.
3. Install the four side bolts.
4. Install two bottom rivets.
5. Install the rear lamp units (Refer to 8 - ELECTRI-
CAL/LAMPS/LIGHTING - EXTERIOR/REAR LAMP
UNIT - INSTALLATION).
6. Install the rear half wheel opening flares (Refer to
23 - BODY/EXTERIOR/WHEEL OPENING FLARE
MOLDING - INSTALLATION).
KJ
FRAME & BUMPERS
13 - 5
REAR FASCIA SUPPORT
REMOVAL
1. Remove the rear fascia assembly (Refer to 13 -
FRAME & BUMPERS/BUMPERS/REAR FASCIA -
REMOVAL).
2. Remove the four rivets and remove the two fascia
supports.
3. For export models, remove the seven bolts and
remove the fascia support.
13 - 6
FRAME & BUMPERS
KJ
INSTALLATION
1. For export models, install the fascia support and
install the seven bolts.
2. Install the fascia supports onto the vehicle and
install four new rivets.
3. Install the rear fascia assembly (Refer to 13 -
FRAME & BUMPERS/BUMPERS/REAR FASCIA -
INSTALLATION).
KJ
FRAME & BUMPERS
13 - 7
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст