Jeep Liberty KJ. Manual — part 1282
CAUTION: Do not install the support cylinders by
pressing at the center of the cylinder. Press the
ends only.
2. Install the support cylinder (4) over the ball studs
with the thin end connected to the body side of the
hinge and the retaining clips snapping into place.
23 - 28
HOOD
KJ
LATCH RELEASE HANDLE
REMOVAL
1. Remove the cowl trim panel. (Refer to 23 - BODY/INTERIOR/COWL TRIM COVER - REMOVAL)
2. Remove the three screws and remove the handle.
3. Disconnect the hood release cable.
INSTALLATION
1. Connect the hood release cable to the handle.
2. Install the handle and install the three screws.
3. Install the cowl trim cover. (Refer to 23 - BODY/INTERIOR/COWL TRIM COVER - INSTALLATION)
KJ
HOOD
23 - 29
DOOR - FRONT
TABLE OF CONTENTS
page
page
CHECK STRAP
DOOR
ADJUSTMENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36
DOOR GLASS
EXTERIOR HANDLE
GLASS RUN CHANNEL
HINGE
LATCH
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 47
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 48
LATCH STRIKER
LOCK CYLINDER
TRIM PANEL
WATERDAM
WINDOW REGULATOR - MANUAL
WINDOW REGULATOR - POWER
23 - 30
DOOR - FRONT
KJ
CHECK STRAP
REMOVAL
1. Remove the waterdam. (Refer to 23 - BODY/
DOOR - FRONT/WATERDAM - REMOVAL)
2. Remove screws attaching door check to A-pillar.
3. Remove the two nuts (1) and remove the door
check strap (2).
KJ
DOOR - FRONT
23 - 31
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст