Jeep Liberty KJ. Manual — part 1281
LATCH RELEASE CABLE
REMOVAL
1. Remove the battery. (Refer to 8 - ELECTRICAL/BATTERY SYSTEM/BATTERY - REMOVAL)
2. Remove the hood latch. (Refer to 23 - BODY/
HOOD/LATCH - REMOVAL)
3. Remove the powertrain control module. (Refer to 8
- ELECTRICAL/ELECTRONIC CONTROL MOD-
ULES/POWERTRAIN
CONTROL
MODULE
-
REMOVAL)
23 - 24
HOOD
KJ
4. Remove the hood release handle. (Refer to 23 -
BODY/HOOD/LATCH
RELEASE
HANDLE
-
REMOVAL)
5. Disconnect the attaching clips and remove the cable from the inside.
INSTALLATION
1. Install the cable from the inside and attach the retaining clips.
2. Install the hood latch release handle. (Refer to 23 - BODY/HOOD/LATCH RELEASE HANDLE - INSTALLATION)
3. Install the powertrain control module. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES/POWER-
TRAIN CONTROL MODULE - INSTALLATION)
4. Install the hood latch. (Refer to 23 - BODY/HOOD/LATCH - INSTALLATION)
5. Install the battery. (Refer to 8 - ELECTRICAL/BATTERY SYSTEM/BATTERY - INSTALLATION)
KJ
HOOD
23 - 25
SUPPORT CYLINDER
REMOVAL
NOTE: The support cylinders can be replaced one
at a time.
1. Open the hood and support.
NOTE: Lift the clips only enough to release the
ball studs.
2. Using a small flat bladed tool, or equivalent,
release the upper retaining clips while pulling the
ball socket away from the ball stud.
23 - 26
HOOD
KJ
CAUTION: Do not pull the supports from the mid-
dle while removing.
3. Pulling at the ends only, remove the support cylin-
der (4).
INSTALLATION
1. Make sure the retaining clips (1) are seated into
the ball socket (2) fully.
KJ
HOOD
23 - 27
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст