Jeep Liberty KJ. Manual — part 1283
INSTALLATION
NOTE: Make sure the proper orientation of the
check strap is maintained using the part number
(3) printed on the side. The part number should
face inboard toward the interior of the vehicle.
1. Install the check strap (2) through the speaker hole
(4).
2. Install the nuts (1) and tighten to 12 N·m (9 ft. lbs.).
3. Connect the strap to the A-pillar and tighten the
bolts to 12 N·m (9 ft. lbs.).
4. Install the waterdam. (Refer to 23 - BODY/DOOR -
FRONT/WATERDAM - INSTALLATION)
23 - 32
DOOR - FRONT
KJ
DOOR
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Disconnect the door wire harness electrical con-
nector at the A-pillar.
3. Support the door with a suitable lifting device.
4. Remove the bolts attaching the check strap to the
A-pillar.
NOTE: The epoxy washers should not be removed
from the hinge. If the washers are removed the
door may have to be re-adjusted.
5. Remove the nuts attaching the door hinges to the
door.
6. Carefully remove the door from the body.
KJ
DOOR - FRONT
23 - 33
7. If necessary, remove the front door hinges from the
door (Refer to 23 - BODY/DOOR - FRONT/HINGE
- REMOVAL).
INSTALLATION
1. If removed, install the front door hinges (3) onto the
door (Refer to 23 - BODY/DOOR - FRONT/HINGE
- INSTALLATION).
23 - 34
DOOR - FRONT
KJ
2. Carefully position the door to the body and support
the door with a suitable lifting device.
3. Loosely install the four bolts (2) that secure the
front door hinges to the A-pillar.
4. Align the door to the body using the reference
marks made during the removal procedure.
5. Tighten the hinge to body bolts to 28 N·m (21 ft.
lbs.) using the sequence shown.
6. Connect the front door wire harness to the body
wire harness.
7. Reconnect the negative battery cable.
8. If necessary, adjust the front door (Refer to 23 -
BODY/DOOR-FRONT - ADJUSTMENTS).
KJ
DOOR - FRONT
23 - 35
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст