Jeep Liberty KJ. Manual — part 1342
TROUGH
REMOVAL
1. Remove the glass panel. (Refer to 23 - BODY/
SUNROOF/GLASS PANEL - REMOVAL)
2. Through the top of the roof opening remove two
screws (3) from trough assembly (1).
3. Remove trough assembly (1).
INSTALLATION
NOTE: When installing the trough be sure the
trough crosses over the top of the sunshade.
1. Install the trough (1) and install the two screws (3).
2. Install the glass panel. (Refer to 23 - BODY/SUN-
ROOF/GLASS PANEL - INSTALLATION)
23 - 268
SUNROOF
KJ
WIRING
REMOVAL
1. Remove the headliner. (Refer to 23 - BODY/INTE-
RIOR/HEADLINER - REMOVAL)
2. Disconnect wire harness from vehicle harness (2).
3. Disconnect drive motor electrical connector (4) and
cut tie straps (5).
4. Remove harness (1).
KJ
SUNROOF
23 - 269
INSTALLATION
1. Connect drive motor (4) electrical connectors.
2. Replace the two tie straps (5) on the module
assembly (3).
3. Connect vehicle harness electrical connectors (2).
4. Install the headliner. (Refer to 23 - BODY/INTERI-
OR/HEADLINER - INSTALLATION)
23 - 270
SUNROOF
KJ
WEATHERSTRIP/SEALS
TABLE OF CONTENTS
page
page
A-PILLAR SEAL
COWL WEATHERSTRIP
DOOR PRIMARY WEATHERSTRIP
DOOR LOWER WEATHERSTRIP
FRONT DOOR OUTER BELT MOLDING
SWING GATE BELTLINE WEATHERSTRIP
SWING GATE OPENING WEATHERSTRIP
REAR DOOR OUTER BELT MOLDING
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 279
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 279
SIDE RAIL WEATHERSTRIP/RETAINER
WINDSHIELD A-PILLAR WEATHERSTRIP/
COWL/PLENUM SEAL
COWL/PLENUM WINDOW BAFFLE SEAL
AIR INLET SEAL
FRONT DOOR INNER BELT WEATHERSTRIP
REAR DOOR INNER BELT WEATHERSTRIP
KJ
WEATHERSTRIP/SEALS
23 - 271
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст