Jeep Liberty KJ. Manual — part 1295
INSTALLATION
1. Connect the latch electrical connectors.
2. Install the latch assembly (1) into the door and
install the screws (2).
3. Tighten the latch screws to 11 N·m (95 in. lbs.).
4. Connect the outside door handle rod at the outside
door handle.
5. Connect the lock knob rod at the bell crank and the
inside handle rod when installing the trim panel.
6. Install the waterdam (1). (Refer to 23 - BODY/
DOORS - REAR/WATERDAM - INSTALLATION)
7. Adjust the latch as needed. (Refer to 23 - BODY/
DOORS - REAR/LATCH - ADJUSTMENTS)
23 - 80
DOORS - REAR
KJ
ADJUSTMENTS
ADJUSTMENT
1. Locate access hole and remove the mylar tape (2)
covering it.
2. Insert a 5/32” hex-wrench through hole and into
adjustment screw (3). Loosen screw.
3. Operate outside handle several times to release
any restriction because of mis-alignment.
4. Tighten adjustment screw to 3 N·m (30 in. lbs.).
5. Test handle for proper operation.
KJ
DOORS - REAR
23 - 81
LATCH STRIKER
REMOVAL
1. Remove the bolts (4).
2. Remove the latch striker (3) and the spacer (2), if
equipped.
INSTALLATION
1. Install the striker (3) and spacer (2), if required.
2. Install the bolts (4) and tighten to 28 N·m (21 ft.
lbs.).
3. Adjust the door as necessary. (Refer to 23 - BODY/
BODY STRUCTURE/GAP AND FLUSH - SPECIFI-
CATIONS)
23 - 82
DOORS - REAR
KJ
TRIM PANEL
REMOVAL
1. Remove the inside handle screw plug and remove
the screw (4).
2. Remove the pull handle screw.
3. Using a trim stick C-4755 or equivalent, disengage
the trim panel clips (5) and remove the trim panel.
4. Disconnect the electrical connectors and the inside
handle actuator rod (3).
KJ
DOORS - REAR
23 - 83
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст