Jeep Liberty KJ. Manual — part 1306
4. Install the hood seal (1).
23 - 124
EXTERIOR
KJ
EXTERIOR NAME PLATES
REMOVAL
1. Apply a length of masking tape on the body, paral-
lel to the top edge of the nameplate to use as a
guide, if necessary.
2. Apply a length of masking tape on the body, paral-
lel to the top edge of the nameplate to use as a
guide, if necessary.
KJ
EXTERIOR
23 - 125
NOTE: Exterior nameplates are attached to body
panels with adhesive tape.
3. Apply a length of masking tape on the body, paral-
lel to the top edge of the nameplate to use as a
guide, if necessary.
4. If temperature is below 21°C (70°F) warm emblem with a heat lamp or gun. Do not exceed 52°C (120°F) when
heating emblem.
5. Using a trim stick C-4755 or equivalent, behind the emblem to separate the adhesive backing from the body.
6. Clean adhesive residue from body with MOPAR
T
Super Clean solvent or equivalent.
INSTALLATION
1. Remove protective cover from adhesive tape on
back of emblem.
2. Position emblem properly on body.
23 - 126
EXTERIOR
KJ
3. Position emblem properly on body.
4. Position emblem properly on body.
5. Press emblem firmly to body with palm of hand.
6. If temperature is below 21°C (70°F) warm emblem
with a heat lamp or gun to assure adhesion. Do not
exceed 52°C (120°F) when heating emblem.
KJ
EXTERIOR
23 - 127
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст