Jeep Liberty KJ. Manual — part 1320
On vehicles without a grab handle:
1. Position the passenger side bezel (5) and seat the
retaining clips.
On vehicles equipped with a grab handle:
1. Install the grab handle (2) and bezel assembly and
install the screws (1).
2. Connect the electrical connector (4), if equipped.
3. Position the end caps (3) in place and seat fully.
23 - 180
INSTRUMENT PANEL
KJ
KNEE BLOCKER
REMOVAL
1. Before proceeding with the following repair proce-
dure, review all warnings and cautions. (Refer to
23 - BODY/INSTRUMENT PANEL - WARNING)
2. Reach into the steering column opening at the top
of the knee blocker and pull the top rearward to
disengage upper knee blocker clips (2).
3. Gently swing the knee blocker open.
4. Slide the knee blocker toward the driver side door
and disengage the hinges (1) from the molded in
hinge pins in the instrument panel.
INSTALLATION
1. Before proceeding with the following repair proce-
dure, review all warnings and cautions. (Refer to
23 - BODY/INSTRUMENT PANEL - WARNING)
2. With the knee blocker close to a horizontal posi-
tion, align both knee blocker hinges (1) to the tabs
at the bottom edge of the instrument panel.
3. engage the hinges by sliding them toward the cen-
ter of the vehicle as far as they can go.
4. Gently swing the knee blocker upward until the
clips (2) touch the corresponding slots in the instru-
ment panel and engage fully.
KJ
INSTRUMENT PANEL
23 - 181
INTERIOR
TABLE OF CONTENTS
page
page
4WD FLOOR SHIFT BOOT
A-PILLAR TRIM AND GRAB HANDLE
COWL TRIM COVER
DOOR SILL SCUFF PLATE
ASSIST HANDLE
B-PILLAR LOWER TRIM
B-PILLAR UPPER TRIM
CARPETS AND FLOOR MATS
SHIFT BEZEL
FLOOR CONSOLE
FLOOR CONSOLE LID LATCH
HEADLINER
QUARTER TRIM PANEL
REAR DOOR SCUFF PLATE
SUN VISOR
SUN VISOR SUPPORT
REAR VIEW MIRROR
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 204
INSTALLATION
. . . . . . . . . . . . . . . . . . . . . . . 204
23 - 182
INTERIOR
KJ
4WD FLOOR SHIFT BOOT
REMOVAL
1. Separate the boot bezel from the console (2).
2. Release the upper snap and remove the boot (1)
from the shifter.
INSTALLATION
1. Position the boot (1) over the top of the transfer
case shifter lever with the snap facing toward the
front of the vehicle.
2. Seat the bezel into the console (2) aperture fully.
3. Fasten the snap on the top of the boot above the
ring on the bottom of the knob.
KJ
INTERIOR
23 - 183
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст