Engines Iveco C87 / Cursor 87. Manual — part 14
Fittings of pipelines, cooling water and turbocharger
lube oil must be locked at:
-
35
± 5Nm, water pipeline fittings;
-
55
± 5Nm, oil pipeline female fitting;
-
20-25 Nm, oil pipeline make fitting.
NOTE
114291
Use specific equipment (2) to install belt (1) on belt tensioner,
in direction shown by arrow.
Belt tensioner is automatic, therefore no further
adjustments are required after installation.
NOTE
ENGINE ASSEMBLY COMPLETION
Complete engine assembly fitting or connecting parts below:
-
complete fuel filter support and pipelines;
-
EDC ecu;
-
intake manifold with pre-heating resistor;
-
heat exchanger;
-
exhaust manifold;
-
turbocharger and related water and oil;
-
pulley and damper flywheel assy (install fixed guide pulley
5, Figure 3, before assy);
-
thermostat assy;
-
belt tensioner, water pump, alternator;
-
oil level rod;
-
start-up motor;
-
oil filter;
-
electric connections and sensors (See diagram on page
30).
Figure 75
114029
Rotate engine.
Fit seal (4) on oil sump (1), fit spacer (3) and install sump on
engine block locking screws (2) at required torque.
Figure 76
114031b
Install suction rose (1).
Figure 77
SECTION 3 - INDUSTRIAL APPLICATION
25
F2C CURSOR ENGINES
A. Fuel temperature sensor - B. Engine rpm sensor on camshaft - C. Starter motor - D. EDC 7 control unit - E. Conditioner
compressor - F. Pressure/temperature transmitter - G. Temperature/air pressure sensor -
H. Alternator - I. Resistance for engine warming - L. Connector on engine block for connection with electro-injectors -
M. Water temperature sensor - N. Engine speed on flywheel sensor - O. Fuel adjustment valve on high pressure pump
Figure 1
114294
SECTION 3 - INDUSTRIAL APPLICATION
29
F2C CURSOR ENGINES
Components on the engine F2C
119974
Figure 2
Engine cable
30
SECTION 3 - INDUSTRIAL APPLICATION
F2C CURSOR ENGINES
Base - June 2006
FUNCTION
78247
Fuel injector
85157
Fuel pressure sensor on rail
85153
Engine coolant temperature sensor
85156
Air pressure and temperature sensor
42030
Engine oil pressure sensor
47032
Engine oil temperature sensor
78013
Camshaft sensor
47042
Fuel temperature sensor
48035
Driving shaft sensor
48042
Camshaft sensor
ST
Cable routing inside head
119977
Figure 3
EDC 7 UC31 control unit pin-out
SECTION 3 - INDUSTRIAL APPLICATION
31
F2C CURSOR ENGINES
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст