Geely FC. Manual part — 18
Geely FC. Manual part - 18
Cooling - Water pump assembly
Water pump assembly
Replacement
1. Remove engine right bottom shield.
2. Discharge engine coolant.
3. Remove drive belt.
Slowly turn drive belt tensioner clockwise to loosen the belt;
then remove drive belt and put back drive belt tensioner slowly
to completely loosen the tensioner.
4. Remove alternator assembly.
(a) Remove rubber cover and nuts.
(b) Uncouple alternator joint.
(c) Remove 2 bolts and alternator.
5. Remove water pump assembly.
Remove 6 bolts, water pump and o-ring.
69
Cooling - Water pump assembly
6. Install water pump assembly.
(a) Install new o-ring on water pump.
(b) Install water pump with 6 bolts.
Torque: bolt A:
Bolt B:
7. Install alternator mounting components.
Torque: 12mm bolt head:
14mm bolt head:
8. Refill engine coolant.
9. Check there is leakage with coolant.
70
Cooling - Temperature regulator components
Replacement
1. Remove engine right bottom shield.
2. Discharge engine coolant.
3. Remove drive belt.
Slowly turn drive belt tensioner clockwise to loosen the belt;
then remove drive belt and put back the tensioner slowly to
completely loosen it.
4. Remove alternator components.
(a) Remove rubber cover and nuts.
(b) Uncouple alternator joint.
(c) Remove 2 bolts and alternator.
5. Remove water inlet pipe.
6. Remove temperature regulator.
7. Install temperature regulator.
(a) Install new gasket to temperature regulator.
(b) As shown in the diagram, install temperature regulator with
inching valve toward upward.
8. Install water inlet pipe and joint.
Torque:
9. Install alternator installation components.
Torque: 12mm bolt head:
m
14mm bolt head:
10.
Refill engine coolant.
11.
Check there is leakage with coolant.
71
Temperature regulator components
Cooling - Radiator with electronic fan assembly
Radiator with electronic fan assembly
Replacement
1. Discharge coolant (see Page 73).
2. Disassemble radiator water inlet hose [64000062].
3. Disassemble radiator water outlet hose [64000063].
4. Disassemble No.1 oil cooler inlet pipe (auto gear).
5. Disassemble No.1 oil cooler outlet pipe (auto gear).
6. Disassemble fixing clips of 2 wire harnesses from fan cover.
7. Remove mounting bracket assembly on radiator [64000058].
8. Remove radiator together with electronic fan assembly [64000057].
9. Remove electronic fan together with fan cover assembly [64000060].
(a) Screw off fixed nuts connecting electronic fan together with fan cover assembly with radiator.
(b) Uncouple fan motor joint.
(c) Remove 2 bolts of fan.
(d) Remove fan motor at the same time.
10. Replace and install as sequences opposite to the above.
11. Refill engine coolant (see Page 73).
12. Check there is leakage with coolant (see Page 66).
72
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст