Geely Emgrand X7. Manual part — 687
Geely Emgrand X7. Manual part - 687
Installation Procedure:
1. Align 9 buckles at the back of rear column upper
trimming plate with mounting hole, and press
trimming plate fixing buckle.
NL12-0163b
2. Install hexagonal fixing bolt of rear column
upper trimming plate.
Torque: 8 Nm (Metric) 5.9 lb-ft (English system)
NL12-0164b
3. Install fixing bolt trimming cover of upper
trimming plate of rear column.
4. Install the rear column lower trim panel.
NL12-0151b
2747
12.9.1.7 Left front door interior trim plate replacement
Dismantlement Procedure
Warning!
Warning: Refer to "Warning on Battery
Disconnection" in "Warnings and Precautions".
Notes:
Please dismantle the trim panel with a special-purpose
body repair tool; otherwise this will easily cause the
trim panel to be damaged.
1. Disconnect the battery negative cable. Refer to
2.11.8.1 Battery Cable
Disconnection/Connection Procedures.
2. Loosen 2 buckles of door inner angle trimming.
3. Disconnect high -pitch speaker harness
connector, Dismantle angle trim.
NL12-0165b
4. Remove 2 cross recessed screws used to fix front
door inner trimming plate.
NL12-0166b
5. Disengage 9 internal buckles for the internal trim
panel of the front door.
6. Disconnect the harnes connectors of the front
door lamp and window lifter switch.
7. Dismantle the front door trim panel.
8. Detach the control cable of the internal door
handle.
NL12-0167b
2748
9. Dismantle the internal door handle assembly.
NL12-0168b
Installation Procedure:
Notes:
Fixed buckle must be replaced by new part.
1. Install door outer opening handle.
NL12-0168b
2. Connect door inner opening handle cable.
3. Connect wire harness connector between front
door inner trimming plate door lamp and glass
lifter switch.
4. Secure the front door trim buckle aligning to the
installation hole and pressing the car trim tab.
NL12-0167b
2749
5. Install and fix 2 cross recessed screws for the
internal trim panel of the front door.
Torque: 5 Nm (Metric) 3.7 lb-ft (English system)
NL12-0166b
6. Connect the front door high pitch loudspeaker
harness connector and align 2 buckles for the
internal door trim corner to the installation holes
and press the internal door trim panel to engage
the buckles.
Notes:
The method for disassembling the left and right front
door inner trim panels is similar.
NL12-0503b
2750
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст