Geely Emgrand X7. Manual part — 684
Geely Emgrand X7. Manual part - 684
12.9.1.2 Left/right front post trim plate assembly replacement
Dismantlement Procedure
Notes:
Please dismantle the front left/right pillar top trim
panel assembly with a aspecial-purpose body repair
tool, otherwise this will easily cause the pillar trim
panel to be damaged.
1. Remove 2 D buckles and 1 connecting buckle on
the back of front column upper trimming plate.
2. Upward draw out upper trimming plate of front
column.
NL12-0144b
Installation Procedure:
1. Insert front column upper trimming plate lower
end into instrument table clip slot.
2. Align buckle of upper trimming plate of front
column with mounting hole, and tighten buckle
by force.
NL12-0145b
2735
12.9.1.3 Middle post trim plate replacement
Dismantlement Procedure
Notes:
Please dismantle the pillar trim panel assembly with a
special-purpose body repair tool, otherwise this will
easily cause the pillar trim panel to be damaged.
1. For dismantling of front and rear doorsill inner
trimming plate assembly, refer to
12.9.1.1
Replacement of left/right front doorsill inner
trimming plate assembly.
2. Dismantle the fixing bolt of middle column lower
seat belt mounting panel.
NL12-0148b
3. Loosen middle 2 D-buckles under the back of
lower trimming plate of middle column and two
equipped clip tones on the upper of back side of
lower trimming plate of middle column.
4. Dismantle lower trimming plate of middle
column.
NL12-0147b
5. Dismantle the fixing screw cap for the upper trim
panel of the center pillar.
NL12-0146b
2736
6. Remove the hexagon bolt on the upper trim panel
on the center pillar.
NL12-0149b
7. Detach 3 buckles on the back of the center pillar
top trim panel.
8. Take down upper trim plate of intermediate post.
NL12-0150b
Installation Procedure:
Notes:
Fixed buckle must be replaced by new part.
1. Install 3 D-buckles onto the back of upper
trimming plate of middle column.
2. Align buckle of upper trimming plate of middle
column with mounting hole, and press trimming
plate to tighten buckle.
NL12-0150b
2737
3. Install 6. hexagon bolts on the intermediate post
upper trim plate
Torque: 8Nm (Metric system) 5.9lb-ft (English
system)
NL12-0149b
4. Install trimming cover of upper trimming plate
screw hole of middle column.
NL12-0151b
5. Align 2 buckles on the bottom of the back of the
lower trim panel of the center pillar and the
clamping tongues on both sides to the installation
holes.
6. Fasten the buckle and clamping tongue by
pressing the lower center pillar trimp panel.
NL12-0149b
2738
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст