Geely Emgrand X7. Manual part — 118
Geely Emgrand X7. Manual part - 118
6. Gradually tighten the camshaft
cover bolts according to the
sequence as shown in the graph.
Note: Tighten the bolts during
several stages. Do not tighten at once
which may damage the camshaft and
the camshaft cover.
Torque :M6 bolt
13±1 Nm (Metric) 10±0.74 lb-ft
(English system)
M8 Bolt
30±1 Nm (Metric) 22 . 1±0 . 74 lb-ft
(English system)
10
9
5
1
3
7
2
4
6
8
GC02-0049c
7. Install the exhaust camshaft
sprocket.
Note: Inspect the sprocket pin wear.
If there is wear, replace the sprocket
pin. Hold the camshaft with a wrench
and then tighten the VVT actuator
bolts.
Torque: 50±3 Nm (Metric) 36.9±2.2
lb-ft (English system)
8. Install the intake camshaft VVT
actuator.
Note: Inspect the VVT actuator pin
wear. Hold the camshaft with a
wrench and then tighten the sprocket
bolts.
Torque: 60±3 Nm (Metric) 44.2±2.2
lb-ft (English system)
8. Install timing chain
9. Install the timing chain cover.
10. Install the drive belt.
11. Install the cylinder hood cover.
12. Install the plastic shield of
engine.
13. Connect battery negative cable.
FE02-3021b
471
2.6.8.13 Replacement of Engine
Dismantlement Procedure
1. For dismantling of battery negative cable, refer to disconnection procedure of battery
negative cable.
2. Release the fuel pressure. Refer to 2.3.8.1 Fuel Pressure Release Procedure.
3. Discharge engine coolant. Refer to 2.8.8.1 Engine Coolant Discharge and Filling.
4. Refer to 2.8.8.2 "Replacement of Coolant Recovery Reservoir" to dismantle the coolant
recovery reservoir.
5. Recover the air-conditioning refrigerant. Refer to 8.2.7.12 Air-conditioning Refrigerant
Recovery and Filling.
6. Remove battery base plate. Refer
to 2.12.6.2 Battery Replacement.
7. Refer to 12.8.3.3 "Replacement
of Glove Box of the Instrument
Panel" to dismantle the glove box
of the instrument panel.
8. Disconnect the engine control
unit and engine harness to the
instrument panel harness
connectors.
NL02-0002c
9. Pull the engine harness out of the
firewall.
NL02-0001c
472
10. Disconnect front and rear oxygen
sensor wiring harness connectors.
NL02-0003c
11. Dismantle the air-conditioning
compressor high and low
pressure connecting tubes.
NL02-0174b
12.
Dismantle intake air pipe
assembly.
13. Dismantle the radiator output
pipe.
Warning: Refer to "Warning on
Maintenance of Cooling System" in
"Warnings and Precautions".
NL02-0176b
473
14. Dismantle the radiator inlet
pipes.
GC02-0051c
15. Dismantle the vacuum booster
vacuum tubes.
NL02-0004c
16. Dismantle the fixing bolts of
clutch fuel tube bracket.
17. Dismantle fixing bolts of clutch
slave cylinder.
NL02-0180b
474
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст