Geely Emgrand X7. Manual part — 119

18. Dismantle the engine wiring

harness to the engine cabin
junction box connecting cables
and connectors.

NL02-0181b

19. Dismantle battery negative cable

gearbox shell grounding point.

NL02-0005c

20. Dismantle the fuel pipe.

NL02-0006c

475

21. Dismantle the canister vacuum

tubes.

NL02-0007c

22. Dismantle gear shift lever cable.

GC03-0036b

23. Dismantle the heater intake and

outlet pipes.

NL02-0186b

476

24. Dismantle the front wheels.

25. Lifting and Jacking the Vehicle

Warning: Refer to Warning on
Vehicle Lifting and Jacking in
Warnings and Precautions.

26.

Dismantle the gearbox oil
discharge bolts until all the
gearbox oil is discharged and
reinstall. Refer to 3.3.6.1
Gearbox Oil Level Inspection.

27. Dismantle the power steering

gear tie rod lateral pin bolts.

Warning: Before remove the
steering lateral pin bolt, remove the
key from the ignition switch first
and turn the steering wheel to lock
position. Otherwise it will damage
the airbag clock spring.

NL02-0187b

28. Refer to 12.6.4.3 "Replacement

of Longitudinal Beam of Front
Suspension" and 12.6.4.4
"Replacement of Front
Subframe" to dismantle the
longitudinal beam of front
suspension, subframe and
associated connectors.

29. Dismantle left and right drive

shaft. Refer to 5.3.4.2
Replacement of drive shaft.

30. Place a mobile working table

under the engine assembly to
lower and support the powertrain
assembly.

Warning: Make sure solid contact
between the working table and the
powertrain, otherwise it will result
in human injury.

NL03-0009c

477

31. Dismantle the engine right

suspension assembly .

32. Dismantle the gearbox left

suspension assembly .

33. Lift the vehicle slowly to

separate powertrain from the
frame .

Note: In the lifting process, avoid the
powertrain assembly tilt on the
working table. Pay attention to the
powertrain and vehicle body
interference.

34. Use an engine lifting device to

support the engine and then
separate the engine and the
gearbox. Refer to 3.3.6.3
Replacement of Gearbox.

NL02-0008c

Installation Procedure:

1. Use the engine lifting device to support the engine and then connect the engine assembly and

the gearbox assembly.

2. Place the powertrain assembly on the mobile working table, lift the vehicle and move the

working table so the powertrain assembly moves back into the vehicle body frame.

3. Slowly lower the vehicle. Pay attention in the lowering process; do not interfere with the

vehicle body frame.

Note: Make sure solid contact between the working table and the powertrain, otherwise it will
result in personal injury.

4. Install the engine right

suspension assembly.

Torque :45Nm (Metric) 33 . 3lb-ft
(English system)

5. Install the gearbox left

suspension assembly.

Torque :50Nm (Metric) 37lb-ft
(English system)

6. Lifting and Jacking the Vehicle

7. Install the left and right drive

shafts.

8. Install the longitudinal beam of

front suspension and front
subframe.

NL02-0008c

478