Geely Emgrand X7. Manual part — 111
Geely Emgrand X7. Manual part - 111
A. Dismantle the drive belt. Refer to 2.6.8.3 Replacement of Drive Belt.
B. Run the engine, but no more than 30 s.
Does the hum sound disappear?
3
Inspect whether the bearings of all accessory drive belt pulleys are normal?
Pulley bearings do not appear stuck, loose and so on.
4. Loosening diagnosis of drive belt
Diagnostic tip: the drive belt dropped from the drive belt pulley repeatedly may be caused by
dislocation of the belt pulley. If the attachment drive belt driving components cause the load
fluctuates, it may cause drive belt fall off from the pulley. Test whether accessories driving
components are working correctly. If the drive belt's length is not proper, drive belt tensioner will
not be able to maintain a suitable drive belt tension.
Fault Definition: Drive belt falls off from the pulley, or are incorrectly installed on the
pulley.
1
Inspect the drive belt for damage. If necessary, replace the drive belt.
2
Inspect whether the pulley is misaligned. Repair the faulty part.
3
Inspect whether the pulley is bent or depressed. Repair the faulty part.
4
Inspect whether the drive belt tensioner device bracket is bent or cracked.
Repair the faulty part.
4
To Diagnostic Hints
Next
Next
Next
Next
No
Replace the damaged pulley or bearing.
Yes
No
Refer to 2.6.7.4 Engine Noise Diagnosis
Yes
443
5
Inspect whether the drive belt tensioner device is working properly. Repair
the faulty part.
6
Inspect whether the drive belt tensioner device is working properly. Repair
the faulty part.
7
Inspect whether the attached fasteners loose. Repair the faulty components.
8
Confirm that the fault has been fixed.
5. The transmission belt is subject to excessive wear.
Diagnostic tip: the excessive wear of the drive belt is usually caused by improper installation or
the user of the wrong belt. Drive pulley slight misalignment will not cause excessive wear and tear,
but it could lead to drive belt noise or loss. Drive pulley misalignment can cause excessive wear
and can also lead to drive belt fall off.
Fault Definition: The drive belt is not properly installed which led to the drive belt outer
edges worn.
1
Inspect whether there are frictions between drive belt and brackets, harness, hoses and
other components?
2
Inspect all attachments drive belt pulley for whether there are abnormal scratches on
the surface, edges and corners and other abnormal conditions?
3
Inspect whether the installed drive belt model is correct?
Yes
Replace the drive belt with a correct type.
No
Yes
Repair the faulty part. If necessary, replace
the belt pulley
No
Yes
Repair the faulty part.
No
Next
Next
Next
444
4
To Diagnostic Hints
445
2.6.8 Removal and installation
2.6.8.1 Replacement of Plastic Shield of Engine
Dismantlement Procedure
1. Dismantle the plastic shield of
engine.
Note: Do not damage the rubber
gasket in the plastic shield when
disassembling.
NL02-1007e
Installation Procedure:
1. Install the plastic shield of
engine.
NL02-1008e
446
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст