Geely Emgrand X7. Manual part — 349
Geely Emgrand X7. Manual part - 349
3.5.7.5 Gears switch replacement
Dismantle procedure
1. Disconnect the battery negative cable. Refer to
2.12.6.1 Battery disconnection.
2. Disconnect wire harness of gear switch.
SL03-0021c
3. Disconnect connection of shift flexible shaft and
gears switch.
4. Dismantle gear switch fixing nut.
5. Dismantle the gear switch.
SL03-0022c
Installation procedure::
1. Install gear switch.
2. Install operating rod of gear switch, and tighten
fixing nut.
3. Connect to shift flexible shaft, and tighten fixing
nut .
4. Connect wire harness connector of gear switch.
5. Connect battery negative cable.
SL03-0023c
1395
3.5.7.6 Automatictransmission assembly replacement
Dismantle procedure
1. Disconnect the battery negative cable. Refer to
2.12.6.1 Battery disconnection.
2. Dismantle battery base plate. Refer to 2.12.6.2
Battery replacement.
3. Dismantle the air filter base.
4. Disconnect wire harness connector between
electromagnetic valve and gear switch;
5. Disconnect the crankshaft position sensor harness
connector.
6. Dismantle the fixing bolt for the negative earth
on the transmission and disconnect the harness
connector of the negative earth.
SL03-0024c
7. Disconnect connection of shift flexible shaft and
gears switch.
8. Dismantle the shift lever bracket;
9. Dismantle the shift lever retaining pin.
SL03-0022c
10. Dismantle oil drain bolt of transmission. After
transmission oil is totally drained out, install it.
Refer to 3.5.7.3 Replacement procedure of
automatic transmission oil.
SL03-0018c
1396
11. Dismantle oil inlet pipe of transmission ,
Notes:
● For just stopping vehicle, oil temperature in
transmission is high, it is necessary to prevent
injury by hot oil flowed from transmission.
● Before dismantling cooling oil pipe joint, clean
neighboring dust, to ensure no dust enters into
oil pipe and transmission.
● After dismantling of oil inlet and outlet pipe of
transmission, the port of pipe and joint must be
covered with protective cap;
SL03-0025c
12. Dismantle the starter cable and the fixing bolts.
13. Dismantle connecting bolt of left suspension and
transmission
14. Dismantle the transmission upper connecting
bolts;
NL03-2008c
15. Use special tool to fix the engine.
NL03-1002e
1397
16. Dismantle fixing bolt B for rear suspension and
auxiliary frame and through bolt A of rear
suspension.
B
A
NL03-2007c
17. Dismantle the two front wheels;
18 Lifting vehicle
Warning: Refer to Warning for lifting vehicle in
Warnings and Precautions.
19. Dismantle the steering cross pin bolt
20. Dismantle fixing bolt of lower protective plate
and left and right bracket of horizontal beam, and
take out bracket.
FE03-0171b
21. Respectively dismantle fixing bolt of reinforced
plate of front auxiliary frame on both sides.
NL12-0081b
1398
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст