Geely EC718, EC718RV, EC715, EC715RV. Manual part — 433
Geely EC718, EC718RV, EC715, EC715RV. Manual part - 433
Rear Wiper Motor Harness Connector SO47
I/P Fuse Harness Connector C05
FE11-5528c
(a)
Repair the circuit between the I/P block C05 terminal I and
the rear wiper motor wiring harness connector terminal No.2.
Confirm the repair completed.
Next
Step 13
System normal.
Body Electric
Wipers / Washers System
11-245
11.6.7.9 Rear Washer Inoperative (Hatchback)
Schematic:
Wiper/Washer Switch
Rear Wiper Switch
Body Control Module (BCM)
To Front Wiper Switch
Rear Washer Motor
To Fuse Block
FE11-5516c
Diagnostic Steps:
Step 1
Check the washer fluid level.
(a)
Check whether the washer fluid is sufficient.
Yes
No
Step 2
Add the washer fluid.
(a)
Add the washer fluid.
Confirm the rear washer is working correctly.
11-246
Wipers / Washers System
Body Electric
Yes
System normal
No
Step 3
Check the rear washer hose and nozzle.
(a)
Check the windshield washer hose and nozzle for blockage /
damage / leaking.
No
Yes
Step 4
Repair hoses and nozzles.
(a)
Repair or replace the blocked / damaged / leaking hose and
nozzle scrubbers. Refer to
Confirm the washer is working properly.
Yes
System normal
No
Step 5
Operating the wipers, check the wiper working status.
(a)
If the rear wipers are inoperative, the rear wipers circuit is
faulty. First repair the wipers inoperative. For detailed
procedures. Refer to
wiper
(b)
If the rear wipers work, the wiper switch power supply circuit
is normal, to "B"
A
B
Step 6
Check the rear washer motor ground circuit.
Rear Washer Motor Harness Connector
FE11-5517c
(a)
Disconnect the rear washer motor wiring harness connector.
(b)
Check the continuity between the rear washer motor terminal
No.1 and the ground with a multimeter.
Resistance Standard Value: Less than 1 Ω
Yes
Body Electric
Wipers / Washers System
11-247
No
Step 7
Repair the rear washer motor ground circuit.
(a)
Repair the rear washer motor ground circuit resistance too
high or open circuit.
Is the ground circuit normal?
Yes
System normal
No
Step 8
Measure the rear washer motor terminal No.2 voltage.
Rear Washer Motor Harness Connector
FE11-5518c
(a)
Turn on the ignition switch.
(b)
Turn on the rear washer.
(c)
Measure rear washer motor connector terminal No.2 voltage
with a multimeter.
Standard Voltage: 11-14 V
Is the voltage specified value?
No
Yes
Step 9
Replace the rear washer motor.
(a)
Replace the rear washer motor. Refer to
Washer Pump and Hose Replacement (Hatchback)
.
Confirm the rear wipers are working correctly.
Yes
System normal
No
Step 10
Check the circuit between the rear wiper switch wiring harness connector terminals No.11 and 17.
11-248
Wipers / Washers System
Body Electric
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст