Geely EC718, EC718RV, EC715, EC715RV. Manual part — 430
Geely EC718, EC718RV, EC715, EC715RV. Manual part - 430
Wiper Switch Harness Connector IP19
Front Wiper Motor Harness Connector CA14
FE11-5507b
(a)
Check the circuit between the wiper switch wiring harness
connector terminal No.7 and the wiper motor wiring harness
connector terminal No.1.
(b)
Repair the open circuit between the wiper switch wiring
harness connector terminal No.7 and the wiper motor wiring
harness connector terminal No.1.
Confirm the repair completed.
Next
Step 6
System normal.
11.6.7.6 Wiper Inoperative At Intermittent
Schematic:
Wiper Inoperative At All Speed
Diagnostic Steps:
Step 1
Measure the wiper motor harness connector terminal No.1 voltage.
1
4 5
2 3
Front Wiper Motor Harness Connector CA14
FE11-5503b
(a)
Turn on the ignition switch.
(b)
Turn the wiper switch to "INT" (intermittent) position, measure
the wiper motor harness connector terminal No.1 voltage with
a multimeter.
Standard Voltage: 11-14 V
Is the voltage specified value?
No
Body Electric
Wipers / Washers System
11-233
Yes
Step 2
Replace the wiper motor.
(a)
Replace the wiper motor repair. Refer to
Is the wiper motor working correctly?
Yes
System normal
No
Step 3
Measure the wiper switch wiring harness connector terminal No.7 voltage.
Wiper Switch Harness Connector IP19
FE55-5511b
(a)
Turn on the ignition switch.
(b)
Turn the wiper switch to "INT" (intermittent) position.
(c)
Measure the wiper motor wiring harness connector terminal
No.7 voltage with a multimeter.
Standard Voltage: 11-14 V
Is the voltage specified value?
Yes
No
Step 4
Replace the wiper switch.
(a)
Refer to
Wiper and Washer Switch Replacement
.
Are the wipers working properly?
Yes
System normal
No
Step 5
Check the circuit between the wiper switch wiring harness connector terminal No.7 and the wiper motor
connector terminal No.1.
11-234
Wipers / Washers System
Body Electric
Wiper Switch Harness Connector IP19
Front Wiper Motor Harness Connector CA14
FE11-5507b
(a)
Check the circuit between the wiper switch wiring harness
connector terminal No.7 and the wiper motor connector
terminal No.1.
(b)
Repair the open circuit between the wiper switch wiring
harness connector terminal No.7 and the wiper motor
connector terminal No.1.
Confirm the repair completed.
Next
Step 6
System normal.
Body Electric
Wipers / Washers System
11-235
11.6.7.7 Front Washer Inoperative
Schematic:
Wiper/Washer Switch
Washer Switch
Front Wiper Motor
To Fuse Block
FE11-5525b
Diagnostic Steps:
Step 1
Check the windshield wipers working status.
(a)
Turn on the ignition switch.
(b)
Turn the wiper switch to "LOW" (low speed) position.
Confirm that the windshield wipers work after the switch is turned
on.
Yes
11-236
Wipers / Washers System
Body Electric
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст