Geely EC718, EC718RV, EC715, EC715RV. Manual part — 145
Geely EC718, EC718RV, EC715, EC715RV. Manual part - 145
FE02-0354b
1.
Discharge the engine coolant. Refer to
2.
Remove the drive belt. Refer to
3.
Remove the two short water pump retaining bolts.
FE02-0355b
4.
Remove the four long water pump retaining bolts.
FE02-0356b
5.
Remove the water pump.
Engine
Cooling System JL4G18-D
2-495
FE02-0357b
6.
Remove the water pump seals.
Water Pump Inspection:
Warning!
Refer to "Protective Goggles and Glove Warning" in
"Warnings and Notices".
FE02-7812b
1.
Check whether the pump body is cracking and leaking.
2.
Check whether the water pump bearing has a gap or
abnormal sound.
3.
Check whether the water pump pulley has serious wear
and tear. If the pump is damaged, replace the pump.
Installation Procedure:
FE02-0358b
1.
Clean the water pump seal groove and mating surface.
2-496
Cooling System JL4G18-D
Engine
FE02-0359b
2.
Install new water pump seals.
Note
The pump seal is a single used part and must be
replaced with new parts. after removal.
FE02-0355b
3.
Install the four long bolts, but do not tighten at this stage.
FE02-0354b
4.
Install the two short bolts, but do not tighten at this stage.
Engine
Cooling System JL4G18-D
2-497
2
4
6
3
1
5
FE02-0360b
5.
Tighten the water pump retaining bolts according to the
sequence in the graphic.
Torque
Short Water Pump Retaining Bolts: 9 Nm (Metric) 6.7 lb-
ft (US English)
Long Water Pump Retaining Bolts: 11 Nm (Metric) 8.2 lb-
ft (US English)
6.
Install the drive belt.
7.
Fill the engine coolant.
2-498
Cooling System JL4G18-D
Engine
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст