Geely EC718, EC718RV, EC715, EC715RV. Manual part — 510
Geely EC718, EC718RV, EC715, EC715RV. Manual part - 510
12.4.3 Removal and Installation
12.4.3.1 Front Bumper Replacement
Removal Procedure:
Warning!
Refer to "Battery Disconnect Warning" in "Warnings and
Notices"
FE12-0145b
1.
Disconnect the battery negative cable. Refer to
.
2.
Remove the radiator grille panel from the front end
module.
FE12-0146b
3.
Remove the front bumper retaining screws from the sides
and the bottom.
4.
Remove the front bumper.
5.
Disconnect the front fog lamp harness connectors.
6.
prior to remove
Remove the front fog lamps. Refer to
.
7.
Remove the front fog lamp covers before removal.
Body, Sheet Metal and Painting
Bumpers
12-29
FE12-0147b
8.
Remove the six radiator grille panel to the front bumper
retaining screws and remove the radiator grille panel.
Note
Hatchback radiator grille has two retaining screws.
FE12-0148b
9.
Remove the front bumper fascia reinforcements from both
sides.
Installation Procedure:
FE12-0149b
1.
Install the front bumper fascia reinforcements.
Torque :9-13 Nm (Metric) 6.7-9.6 lb-ft (US English)
2.
Install the front fog lamp covers.
3.
Install the radiator grille panel to the front bumper.
4.
Install the front fog lamps.
5.
Connect the front fog lamp harness connectors.
6.
Install the front bumper.
7.
Install the front bumper side and bottom retaining screws.
8.
Install the radiator grille panel to the front end module.
Note
The replacement procedure for Hatchback is similar
to that of sedan.
12-30
Bumpers
Body, Sheet Metal and Painting
12.4.3.2
Rear
Bumper
Replacement
(Hatchback)
Removal Procedure:
Warning!
Refer to "Battery Disconnect Warning" in "Warnings and
Notices".
FE12-0151c
1.
Disconnect the battery negative cable. Refer to
.
2.
Remove the two rear bumper upper retaining screws, six
rear bumper to rear wheelhouse liner retaining bolts and
four rear bumper to spare wheel carrier retaining bolts.
Pull the rear bumper from sides to loosen the rear bumper.
FE12-0152c
3.
Disconnect four rear park assist sensor harness
connectors and remove the rear bumper.
4.
Remove four rear park assist sensors. Refer to
Reverse Radar Sensor Replacement
Body, Sheet Metal and Painting
Bumpers
12-31
FE12-0153c
5.
Remove the rear bumper brackets.
Installation Procedure:
FE12-0154c
1.
Install the rear bumper brackets..
Torque: 11 Nm (Metric) 8.1 lb-ft (US English)
2.
Install four rear park assist sensors.
3.
Connect four rear park assist sensor harness connectors.
FE12-0155c
4.
Install the two rear bumper upper retaining screws, six
rear bumper to rear wheelhouse liner retaining bolts and
four rear bumper to spare wheel carrier retaining bolts.
5.
Connect the battery negative cable.
12-32
Bumpers
Body, Sheet Metal and Painting
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст