Geely EC718, EC718RV, EC715, EC715RV. Manual part — 511

12.4.3.3 Rear Bumper Replacement (Sedan)

Removal Procedure:

FE12-0156b

1.

Remove the two rear bumper upper retaining screws, two
clips, six rear bumper to rear wheelhouse liner retaining
bolts and four rear bumper to spare wheel carrier retaining
bolts.

FE12-0157b

2.

Remove the rear compartment trim panel. Refer to

12.9.1.9

Rear Compartment Trim Panel Replacement

.

3.

Remove the rear bumper left and right retaining bolts.

FE12-0152b

4.

Remove four rear park assist sensor harness connectors.

5.

Remove four rear park assist sensors. Refer to

11.14.7.2

Reverse Radar Sensor Replacement

.

Body, Sheet Metal and Painting

Bumpers

12-33

FE12-0158b

6.

Remove the rivets from the rear bumper mounting
brackets and remove the rear bumper mounting brackets.

Installation Procedure:

FE12-0158b

1.

Install the rear bumper mounting brackets to the rear
bumper.

2.

Install four rear park assist sensors.

3.

Connect four rear park assist sensor harness connectors.

FE12-0159b

4.

Install the rear bumper left and right retaining bolts.

5.

Install the two rear bumper upper retaining screws, two
clips, six rear bumper to rear wheelhouse liner retaining
bolts and four rear bumper to spare wheel carrier retaining
bolts.

6.

Install the rear compartment trim panel.

12-34

Bumpers

Body, Sheet Metal and Painting

12.4.3.4 Front Impact Bar Replacement

Removal Procedure:

FE12-0160b

1.

Remove the front bumper. Refer to

12.4.3.1

Front Bumper

Replacement

.

2.

Remove the front impact bar retaining nuts.

FE12-0161b

3.

Remove four retaining nuts from each side of the front
bumper energy absorber.

Installation Procedure:

FE12-0162b

1.

Install four retaining nuts on each side of the front bumper
energy absorber.

Torque: 70 Nm (Metric) 51.8 lb-ft (US English)

Body, Sheet Metal and Painting

Bumpers

12-35

FE12-0163b

2.

Install four front impact bar retaining nuts.

Torque: 70 Nm (Metric) 51.8 lb-ft (US English)

3.

Install the front bumper.

12.4.3.5 Rear Impact Bar Replacement

Removal Procedure:

FE12-0164b

1.

Remove the rear bumper. Refer to

12.4.3.3

Rear Bumper

Replacement (Sedan)

.

2.

Unclip the wiring harness clips.

3.

Remove four retaining nuts from the rear impact bar .

FE12-0165b

4.

Remove four retaining bolts from each side of the rear
bumper energy absorber.

12-36

Bumpers

Body, Sheet Metal and Painting