Двигатели Scania четвёртой серии. Руководство — часть 141
2
ã
03:04-06
Contents
General
. . . . . . . . . . . . . . . . . . . . .. 3
Fault codes
Working procedure . . . . . . . . . . . . ... 4
How to read fault codes from the diagnostic lamp... 5
How to erase fault codes. . . . . . . . . . ... 7
Flashing codes . . . . . . . . . . . . . . .. 8
List of fault codes . . . . . . . . . . . . ... 11
Location of components
. . . . . . . . . . . . . . . . . . . .. 106
Wiring Diagrams
. . . . . . . . . . . . . . . . . . . .. 108
Operational test
. . . . . . . . . . . . . . . . . . . .. 110
Contents
03:04-06
ã
3
EDC S6
General
This booklet contains the following
descriptions:
•
Fault codes — how to present and erase
them.
A list of the flashing codes which can be
read, and the fault codes to which they
correspond.
There is also a complete list of fault codes.
The reason why fault codes are generated
and how to rectify the fault is also described
there. It is the same fault code list that is
found in Scania Diagnos.
•
An operational test. Perform the operational
test after each repair.
General
4
ã
03:04-06
Fault codes
Working procedure
Try to form a comprehensive view of the
problem. Start by asking the driver the
following:
•
Fault symptoms
•
Conditions in which the fault occurs
•
How often the fault occurs
•
If the warning lamp came on when the fault
occurred
•
If the warning lamp went out by itself when
the fault ceased
•
If the driver has erased the fault codes
Compare them and try to conclude the probable
cause of the fault before taking any other
measures. The fault codes are stored in the order
they were registered.
Fault codes
03:04-06
ã
5
How to read fault codes from the diagnostic lamp
Diagnostics switch and diagnostics lamp
EDC
1
18 71
5
How to read the fault codes from the diagnostic
lamp is described below.
You can see how to interpret the flashing codes
on the next page.
1
Switch on the power using the starter key.
2
Press the diagnostic switch and note the
number of short and long flashes. You have
now presented one of the fault codes.
3
Repeat point 2 until you have presented all
the fault codes. If the same fault code is
flashed several times, there may only be one
fault in the system.
Fault codes
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст