Lexus ES300 (1997 year). Manual — part 144
BO09A–03
N21794
Radiator Support Upper Seal
Hood Release Lever
Hood Lock Control Cable
Front Fender Side
Panel Protector
Fender Liner
Hood Lock
N·m (kgf·cm, ft·lbf) : Specified torque
8.0 (82, 71 in.·lbf)
8.0 (82, 71 in.·lbf)
11 (112, 8)
–
BODY
HOOD LOCK CONTROL
BO–9
1187
1997 LEXUS ES300 (RM511U)
HOOD LOCK CONTROL
HOOD LOCK CONTROL
COMPONENTS
BO09B–01
N21381
N21790
A
B
C
A
B
C
BO3863
BO–10
–
BODY
HOOD LOCK CONTROL
1188
1997 LEXUS ES300 (RM511U)
REMOVAL
1.
REMOVE THESE PARTS:
(a)
LH front fender side panel protector
(b)
LH fender liner
(c)
Hood release lever
(d)
Radiator support upper seal
2.
REMOVE HOOD LOCK
(a)
Using a screwdriver, pry out the cap.
HINT:
Tape the screwdriver tip before use.
(b)
Remove the 3 bolts and hood lock.
(c)
Disconnect the link from the lock.
3.
REMOVE HOOD LOCK CONTROL CABLE
(a)
Using a screwdriver, disconnect the cable from the
clamps.
HINT:
Tape the screwdriver tip before use.
(b)
Using a screwdriver, pry out the cable stopper from the
grommet.
HINT:
Tape the screwdriver tip before use.
Do not damage the grommet with the screwdriver.
BO3864
–
BODY
HOOD LOCK CONTROL
BO–11
1189
1997 LEXUS ES300 (RM511U)
(c)
Pull off the cable from the front wheel housing to remove
it.
BO09C–03
N21382
N21783
Rear
Front
N21785
A
B
A
BO–12
–
BODY
HOOD LOCK CONTROL
1190
1997 LEXUS ES300 (RM511U)
INSTALLATION
1.
BEFORE INSTALLING PARTS, COAT LOCK WITH MP
GREASE
Apply MP grease to the sliding surface of the lock.
2.
INSTALL HOOD LOCK CONTROL CABLE
(a)
Push the rear side cable through the grommet.
(b)
Using a screwdriver, push the cable stopper into the
grommet.
HINT:
Tape the screwdriver tip before use.
Do not damage the grommet with the screwdriver.
(c)
Pass the front side cable through the upper radiator sup-
port.
(d)
Install the cable with clamps.
3.
INSTALL HOOD RELEASE LEVER
4.
CHECK HOOD LOCK CONTROL FOR PROPER OP-
ERATION
After checking for proper operation, tighten the 3 bolts to install
the lock.
Torque:
A bolt: 8.0 N·m (82 kgf·cm, 71 in.·lbf)
B bolt: 11 N·m (112 kgf·cm, 8 ft·lbf)
5.
INSTALL THESE PARTS:
(a)
Radiator support upper seal
(b)
LH fender liner
(c)
LH front fender side panel protector
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст