Lexus SC300 / Lexus SC400. Manual — part 409
(c) Connect the following connectors:
(1) Two connectors to engine & ECT ECU
(2) Connectors to ABS & TRAC ECU
(3) Two connectors to TRAC ECU
(4) Four connectors to connector cassette
(5) Connector to A/C control assembly
(d) Install the engine & ECT ECU with the nut.
(e) Install the ECU protector with the two nuts.
(f) Install the floor carpet.
EM–170
–
ENGINE MECHANICAL
Cylinder Block
(g) Install the scuff plate.
(h) Connect the connectors.
(i)
Install the lower instrument panel finish panel and glove
compartment door assembly with the four screws.
(j) Install the instrument panel under cover with the two
clips.
12. INSTALL CHARCOAL CANISTER
(a) Install the charcoal canister.
(b) Connect the vacuum hose and air hose to the charcoal
canister.
13. CONNECT HOSES
Connect the following hose and ground strap:
(1) Heater water hose to water by–pass pipe
(2) Heater water hose to heater water valve
(3) Vacuum hose to brake booster union on air intake
chamber
(4) Vacuum hose (from VSV for heater water valve) to
air intake chamber
(5) Ground strap to bracket on body
–
ENGINE MECHANICAL
Cylinder Block
EM–171
(6) Two fuel hoses to fuel tubes
14. INSTALL A/C COMPRESSOR
(a) Install
the A/C compressor,
compressor
stay
and
ground cable with the nut and three bolts.
Torque: Bolt 49 N
⋅
m (500 kgf
⋅
cm, 36 ft
⋅
lbf)
Nut 29 N
⋅
m (300 kgf
⋅
cm, 22 ft
⋅
lbf)
(b) Connect the A/C compressor connector.
15. INSTALL PS PUMP
Install the PS pump with the three bolts and nut. Alternately
tighten the bolts and nut.
Torque: Bolt 39 N
⋅
m (400 kgf
⋅
cm, 29 ft
⋅
lbf)
Nut 43 N
⋅
m (440 kgf
⋅
cm, 32 ft
⋅
lbf)
16. INSTALL PS RESERVOIR TANK AND BRACKET
Install the reservoir tank and bracket assembly with the three
bolts.
EM–172
–
ENGINE MECHANICAL
Cylinder Block
17. INSTALL
PS
TUBES
Install the PS tube clamp with the bolt.
18. INSTALL
ALTERNATOR
(a) Install the alternator and A/T oil cooler pipe bracket with
the bolt and nut.
Torque: 37 N
⋅
m (380 kgf
⋅
cm, 27 ft
⋅
lbf)
(b) Connect the alternator connector.
(c) Connect the alternator wire with the nut and cap.
19. INSTALL WIRE CLAMP (FOR ALTERNATOR) AND VSV
(FOR EVAP SYSTEM)
(a) Install the wire clamp to the VSV bracket.
(b) Install the VSV with the two bolts.
20. CONNECT PS SOLENOID VALVE CONNECTOR
21. CONNECT ENGINE WIRE CONNECTORS
22. CONNECT THEFT DETERRENT HORN CONNECTOR
23. INSTALL GROUND CABLE TO BODY
–
ENGINE MECHANICAL
Cylinder Block
EM–173
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст