Great Wall Hover. Manual — part 101
Appendix A-5
drive shaft bolt
the fixed torque of bolt 1 in the Figure is 78
5N
m
front axle drive shaft assembly
transmission assembly
rear axle drive shaft assembly
rear axle assembly
petrol lien joint
petrol line joint tightening torque is 16
2 N
torque wrench
petrol pipe joint
two way valve
Appendix A-6
Driver steering oil pump installation
Fixed torque of tubular hexagon bolt 1 in the Figure is
4 0 N
m
Multi-wedge belt
Multi-wedge belt 4PK1100 tension is 500
50N
Torque
Torque
multi-wedge belt 4PK1100
driver steering oil pump
cover lock mounting bolt
effect
c
over lock mounting bolt’s torque is 9
2N
m
the cover lock can be opened freely, the position is reliable
without any jam.
cover lock cable
cover lock buckle
fastening blot
cover lock mounting bracket
Appendix A-7
The fixed torque of bolt 1 in the Figure is 6
1N
m
Out handle can be normally and efficiently used, no linkage
falling off, the backup door can be opened and closed freely
without any jam nor unlocking.
Handle confirmation
rear door assembly
backup door bottom buckle
backup door lock
backup door out handle
The door can be opened and closed smoothly without any jam nor
unlocking.
Torque wrench
door lock assembly
Appendix A-8
front windshield glass
Apply washer on the front windshield
glass-sticking region
Evenly apply it on the sticking region with the width of about
25mm and completely volatilize it.
Viewing confirmation
Viewing confirmation
Apply base-coater on the front
windshield glass-sticking region
Shake the base-coater to be sufficiently even followed by the
even application on the sticking region with the width of about
20mm and dry it for 2-15 minutes
Apply washer on front windshield
glass
Wash the glass frame with the width of about 25mm,
instantly clean it and volatilize the washer completely.
Apply adhesive on front windshield
glass
Shake the glass base-coater to be sufficiently even followed
by the even application on the glass frame with the width of
about 20 and dry it for 2-15 minutes
Apply base-coater on front
windshield glass
Vertically apply the glass adhesive on the glass frame and
make it even and continuous. Height: 18mm, width: 12mm
Front windshield glass fixing
Instantly install and fix the glass after the glass adhesive
application. Set the left and right clearance between front
windshield glass and the glass frame to be 12mm
Viewing confirmation
Viewing confirmation
Viewing confirmation
Viewing confirmation
Wash, base-coat and stick according to the corresponding positions showed by the broken line in the Figure
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст