Mazda 6. Manual — part 284
POWER DOOR LOCK SYSTEM
S–31
S
Door Lock-link Switch
1. Disconnect the front door lock actuator connector.
2. Inspect for continuity between the door lock-link
switch terminals using an ohmmeter.
• If not as specified, replace the front door lock
actuator.
Door Key Cylinder Switch
1. Disconnect the front door lock actuator connector.
2. Inspect for continuity between the door lock-link
switch terminals using an ohmmeter.
• If not as specified, replace the front door lock
actuator.
End Of Sie
A6E7718W008
A6E7718W012
A6E7718W015
A6E7718W022
S–32
POWER DOOR LOCK SYSTEM
REAR DOOR LOCK ACTUATOR INSPECTION
A6E771872310W01
Door Lock Actuator
1. Disconnect the front door lock actuator connector.
2. Apply battery positive voltage to the front door
lock actuator terminals and inspect the operation
of the front door lock actuator.
• If not as specified, replace the front door lock
actuator.
With double locking system
( ) : RH
Without double locking system
( ) : RH
Door Lock-link Switch (With Theft-deterrent System
1. Disconnect the front door lock actuator connector.
2. Inspect for continuity between the door lock-link
switch terminals using an ohmmeter.
• If not as specified, replace the front door lock
actuator.
End Of Sie
TRUNK LID LOCK ACTUATOR INSPECTION
A6E771856840W02
1. Disconnect the trunk lid lock actuator connector.
2. Apply battery positive voltage to the trunk lid lock
actuator terminals and inspect the operation of the
trunk lid lock actuator.
• If not as specified, replace the trunk lid lock.
End Of Sie
Connection
Actuator operation
B+
GND
A
(F)
F
(A)
Lock
F
(A)
A
(F)
Double lock
F and E
(A and B)
E
(A)
Unlock
Actuator operation
Connection
B+
GND
Lock
A
(F)
B
(E)
Unlock
B
(E)
A
(F)
A6E7718W018
A6E7718W010
A6E7718W019
Actuator operation
Connection
B+
GND
Lock
A
B
Unlock
B
A
A6E7718W016
POWER DOOR LOCK SYSTEM
S–33
S
LIFTGATE LOCK ACTUATOR INSPECTION
A6E771862310W01
1. Disconnect the liftgate lock actuator connector.
2. Apply battery positive voltage to the liftgate lock
actuator terminals and inspect the operation of
the liftgate lock actuator.
• If not as specified, replace the liftgate lock.
End Of Sie
DOOR LOCK TIMER UNIT REMOVAL/INSTALLATION
A6E771867830W01
1. Disconnect the negative battery cable.
2. Remove the glove compartment. (L.H.D.)
3. Remove the bolt.
4. While inclining the door lock timer unit along the
body panel in the direction indicated by the arrow,
disengage the bracket hook from the hole in the
body panel.
5. Disconnect the door lock timer unit connector.
6. Remove the door lock timer unit.
7. Remove the screw, then remove the bracket.
Note
• The screw which fixes the door lock timer
unit and bracket is for a body ground
connection. Be sure to secure the screw
when installing.
8. Install in the reverse order of removal.
End Of Sie
Actuator operation
Connection
B+
GND
Lock
A
B
Unlock
B
A
A6E7718W016
A6E7718W004
A6E7718W020
S–34
POWER DOOR LOCK SYSTEM
DOOR LOCK TIMER UNIT INSPECTION
A6E771867830W02
1. Measure the voltage at the door lock timer unit terminals (other than terminal 1E and 2W) as indicated below.
• If not as specified, inspect the parts listed under “Action.”
2. Disconnect the negative battery cable.
3. Disconnect the door lock timer unit connector and inspect for continuity between terminal 1E or 2W and the
bracket.
4. Inspect for continuity at terminal 1E and 2W as indicated below.
5. If the parts and wiring harnesses are okay but the system still does not work properly, perform the troubleshooting.
Terminal voltage list (Reference)
Terminal
Signal
Connected to
Test condition
Voltage (V)/
Continuity
Action
1A
Power
supply
D. LOCK 30 A fuse
Under any condition
B+
• Inspect D. LOCK
30 A fuse
• Inspect the vehicle
battery
• Inspect related
harness
1B
Room light
control
• Front map light
• Rear map light
• Courtesy light
Any door is open
Below 1.0
• Inspect ROOM 15 A
fuse
• Inspect door switch
• Inspect front map light
• Inspect rear map light
• Inspect courtesy light
• Inspect related
harness
1C
Unlock
output
• Door lock
actuator
• Trunk lid lock
actuator (4SD)
• Liftgate lock
actuator (5HB)
While lock actuator is unlocking
Below
1.0
→B+→Below
1.0
• Inspect door lock
actuator
• Inspect trunk lid lock
actuator (4SD)
• Inspect liftgate lock
actuator (5HB)
• Inspect D. LOCK
30 A fuse
• Inspect related
harness
Other
Below 1.0
1D
Lock output
• Door lock
actuator
• Trunk lid lock
actuator (4SD)
• Liftgate lock
actuator (5HB)
While lock actuator is locking
Below
1.0
→B+→Below
1.0
• Inspect door lock
actuator
• Inspect trunk lid lock
actuator (4SD)
• Inspect liftgate lock
actuator (5HB)
• Inspect D. LOCK
30 A fuse
• Inspect related
harness
Other
Below 1.0
1E
Power
ground
GND
Under any condition: inspect for
continuity to ground
Yes
• Inspect GND
1F
*1
Double lock
output
Door lock actuator
Door lock actuators are double
locked
Below
1.0
→B+→Below
1.0
• Inspect door lock
actuator
• Inspect related
harness
Other
Below 1.0
2A
Power
supply
METER IG 15 A fuse Under any condition
B+
• Inspect METER IG
15 A fuse
• Inspect related
harness
2B
IG1
ROOM 15 A fuse
Ignition switch is at ON position
B+
• Inspect ROOM 15 A
fuse
• Inspect related
harness
Ignition switch is at LOCK or
ACC position
Below 1.0
2C
-
-
-
-
-
A6E7718W017
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст