Mazda Protege 5. Manual — part 327
SUNROOF
09–15–5
09–15
REAR DRAIN HOSE INSTALLATION
A3U091569922W02
Caution
••••
If the rear drain hose is pinched or bent anywhere, the water in the hose may not discharge and
enter the inside of the vehicle. During and after installation of the trims and the headliner, always
make sure there is no interference with the rear drain hose. Fix any problem if found.
1. Apply soapy water to the rear drain hose inserting area.
2. Insert one end of the rear drain hose into the sunroof frame.
3. Install the rear drain hose to the clips parallel to the pillar and free of slack.
4. Insert the rear drain hose joint into the rear pillar inner hole.
5. Install the trunk side trim. (See 09–17–15 TRUNK SIDE TRIM REMOVAL/INSTALLATION.)
6. Install the headliner. (See 09–17–16 HEADLINER REMOVAL/INSTALLATION.)
End Of Sie
SUNROOF UNIT REMOVAL/INSTALLATION
A3U091569850W01
1. Disconnect the negative battery cable.
2. Remove the headliner. (See 09–17–16 HEADLINER REMOVAL/INSTALLATION.)
3. Remove the glass panel.
4. Disconnect the front and rear drain hoses from the sunroof frame.
5. Remove the roof harness from the sunroof frame.
6. Remove the bolts and nuts, and then remove the
sunroof unit.
7. Install in the reverse order of removal.
8. Adjust the glass panel. (See 09–15–3 GLASS
PANEL ADJUSTMENT.)
End Of Sie
SUNROOF UNIT DISASSEMBLY
A3U091569850W02
4SD
1. Remove the screws, and then remove the drip
rail.
X3U915WAA
X3U915WAB
X3U915WAC
1712-1U-01G(09-15).fm 5 ページ 2001年6月29日 金曜日 午前10時33分
SUNROOF
09–15–6
2. Remove the sunshade stopper.
3. Slide the sunshade backward, and remove it from
the sunroof frame.
4. Remove the screws, and then remove the rear
drip.
5. Slide the drip shoe backward, and remove it from
the sunroof frame.
6. Remove the sunroof motor.
7. Remove the stopper screw.
8. Slide the guide backward, and remove it from the
sunroof frame.
9. Remove the deflector.
X3U915WAD
X3U915WAE
X3U915WAF
X3U915WAG
1712-1U-01G(09-15).fm 6 ページ 2001年6月29日 金曜日 午前10時33分
SUNROOF
09–15–7
09–15
5HB
1. Bend the hook of the decoration link backward to
remove the drip rail.
2. Remove the sunshade stopper.
3. Slide the sunshade backward, and remove it from
the sunroof frame.
4. Remove the screw, and then remove the guide
stopper.
5. Remove the lock washer using a tape-wrapped
screwdriver.
6. Slide the decoration link backward, and remove it
from the sunroof frame.
7. Remove the sunroof motor.
A3U0915W003
A3U0915W004
A3U0915W005
A3U0915W006
1712-1U-01G(09-15).fm 7 ページ 2001年6月29日 金曜日 午前10時33分
SUNROOF
09–15–8
8. Slide the guide backward, and remove it from the
sunroof frame.
9. Remove the screws.
10. Slide the drive unit forward, and remove it from
the sunroof frame.
11. Remove the deflector.
12. Remove the sunroof relay.
End Of Sie
SUNROOF UNIT ASSEMBLY
A3U091569850W03
4SD
1. Install the deflector.
2. Slide the guide forward, and install it to the sunroof frame.
3. Install the stopper screw.
4. Move the guide by hand until it is tilted up
position.
5. Move the link built into the guide by hand until it is
aligned with mark A and mark B.
6. Install the sunroof motor.
A3U0915W007
A3U0915W008
X3U915WAH
X3U915WAJ
1712-1U-01G(09-15).fm 8 ページ 2001年6月29日 金曜日 午前10時33分
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст