Mazda Protege 5. Manual — part 328
SUNROOF
09–15–9
09–15
7. Slide the drip shoe forward, and install it to the
sunroof frame.
8. Use IPA (Isopropyl alcohol) to remove any excess
repair sealant.
9. Install the screws, and then install the rear drip.
10. Slide the sunshade forward, and install it to the
sunroof frame.
11. Install the sunshade stopper.
12. Install the screws, and then install the drip rail.
5HB
1. Install the sunroof relay.
2. Install the deflector.
3. Slide the drive unit backward, and install it to the sunroof frame.
X3U915WAK
X3U915WAL
X3U915WAM
X3U915WAN
1712-1U-01G(09-15).fm 9 ページ 2001年6月29日 金曜日 午前10時33分
SUNROOF
09–15–10
4. Install the screws.
5. Slide the guide forward, and install it to the
sunroof frame.
6. Move the guide by hand until it is in the tilted up
position.
7. Move the guide by hand until notch comes
between mark A and mark B.
8. Install the sunroof motor.
9. Slide the decoration link forward, and install it to
the sunroof frame.
10. Install the lock washer.
11. Install the screw, and then install the guide
stopper.
A3U0915W009
A3U0915W010
A3U0915W011
A3U0915W012
A3U0915W005
1712-1U-01G(09-15).fm 10 ページ 2001年6月29日 金曜日 午前10時33分
SUNROOF
09–15–11
09–15
12. Slide the sunshade forward, and install it to the
sunroof frame.
13. Install the sunshade stopper.
14. Bend the hook of the decoration link backward to
install the drip rail.
End Of Sie
SUNROOF MOTOR REMOVAL
A3U091569870W01
1. Disconnect the negative battery cable.
2. Remove the headliner. (See 09–17–16 HEADLINER REMOVAL/INSTALLATION.)
3. Disconnect the connector.
4. Remove the screws, and then remove the sunroof
motor.
End Of Sie
SUNROOF MOTOR INSTALLATION
A3U091569870W02
1. Connect the sunroof motor connector.
2. Connect the sunroof switch connector.
3. Connect the negative battery cable.
4. Turn the ignition switch to ON position.
5. Press the CLOSE side of the slide switch until the sunroof motor stops.
6. Disconnect the sunroof switch connector.
7. Install the screws, and then install the sunroof motor.
8. Install the headliner. (See 09–17–16 HEADLINER REMOVAL/INSTALLATION.)
End Of Sie
A3U0915W013
A3U0915W014
A3U0915W015
1712-1U-01G(09-15).fm 11 ページ 2001年6月29日 金曜日 午前10時33分
SUNROOF
09–15–12
SUNROOF MOTOR INSPECTION
A3U091569870W03
4SD
Motor
1. Remove the sunroof motor.
2. Apply battery positive voltage to the sunroof
motor terminals and inspect the operation of the
sunroof motor.
•
If not as specified, replace the sunroof motor.
Limit Switch
1. Remove the headliner. (See 09–17–16 HEADLINER REMOVAL/INSTALLATION.)
2. Verify the glass panel position.
3. Disconnect the connector.
4. Inspect for continuity between the sunroof motor
terminals using an ohmmeter.
•
If not as specified, replace the sunroof motor.
Connection
Motor operation
2A
2B
B+
GND
Turn left (Slide close/Tilt up)
GND
B+
Turn right (Slide open/Tilt down)
A3U0915W025
Y3U915WA1
X3U915WAR
1712-1U-01G(09-15).fm 12 ページ 2001年6月29日 金曜日 午前10時33分
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст