Acura TSX / Honda Accord CL. Manual — part 791
Fig. 67: Pressing The Reverse Selector Hub On The Countershaft
SECONDARY SHAFT DISASSEMBLY, INSPECTION, AND REASSEMBLY
1. Inspect the thrust needle bearing and the needle bearing for galling and rough movement.
Fig. 68: Exploded View Of Secondary Shaft Components
2. Inspect the splines for excessive wear and damage.
3. Check shaft bearing surface for scoring and excessive wear.
4. Before installing the O-rings, wrap the shaft splines with tape to prevent O-ring damage.
5. Lubricate all parts with ATF during assembly.
6. Install the conical spring washer, idler gear in the direction shown.
7. Replace the locknut and conical spring washer with new ones when assembling the transmission. The
locknut has left-hand threads.
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
8. Check the clearance of the 2nd gear (see SECONDARY SHAFT 2ND GEAR CLEARANCE
INSPECTION ) and and 1st gear (see SECONDARY SHAFT 1ST GEAR CLEARANCE
INSPECTION ).
SECONDARY SHAFT BALL BEARING, IDLER GEAR REMOVAL AND INSTALLATION
Special Tools Required
Attachment, 42 mm I.D. 07QAD-P0A0100
Removal
Place a shaft protector (A) on the secondary shaft (B), and set the puller (C) under the idler gear (D), then
remove the idler gear and ball bearing (E).
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
Fig. 69: Removing The Idler Gear And Ball Bearing
Installation
Install the idler gear (A) on the secondary shaft (B), and install the ball bearing (C) over the idler gear with the
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
special tool and a press.
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст