Acura TSX / Honda Accord CL. Manual — part 100
Fig. 72: Adjusting Door Striker
2. Lightly tighten the screws.
3. Wrap the striker with a shop towel, then adjust the striker by tapping it with a plastic hammer (D). Do not
hit the striker too hard.
4. Loosen the screws, and remove the shop towel.
5. Lightly tighten the screws.
6. Hold the outer handle out, and push the door against the body to be sure the striker allows a flush fit. If
the door latches properly, tighten the screws and recheck.
INTERIOR TRIM
COMPONENT LOCATION INDEX
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX
Fig. 73: Locating Interior Trim Components
TRIM REMOVAL/INSTALLATION - DOOR AREA
SRS components are located in this area. Review the SRS component locations and the precautions and
procedures in the SRS section before performing repairs or service. See AIR BAG RESTRAINT SYSTEMS .
Without Side Curtain Airbag
1. Remove the trim as shown.
2. Install the trim in the reverse order of removal, and note these items:
z
Replace any damaged clips.
z
Make sure the opener cable is connected securely.
z
Push the clip portions into place securely.
z
Apply liquid thread lock to the front seat belt upper anchor bolt before installation.
NOTE:
z
Put on gloves to protect your hands.
z
When prying with a flat-tip screwdriver, wrap it with protective tape to
prevent damage.
z
Take care not to bend or scratch the trim and panels.
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX
z
Before installing the anchor bolts, make sure there are no twists or kinks in the belts.
Fig. 74: Removing & Installing Door Area Trim (Without Side Curtain Airbag)
With Side Curtain Airbag
1. Remove the trim as shown.
2. Install the trim in the reverse order of removal, and note these items:
z
If the side curtain airbag have deployed, be sure to check the removed trim pieces for damage
before reinstallation (see AIR BAG RESTRAINT SYSTEMS ), and if necessary, replace them
and trim clips with new ones.
z
If the side curtain airbag have not deployed, removed trim pieces should still be checked for
NOTE:
z
Put on gloves to protect your hands.
z
When prying with a flat-tip screwdriver, wrap it with protective tape to
prevent damage.
z
Take care not to bend or scratch the trim and panels.
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX
damage (see AIR BAG RESTRAINT SYSTEMS ), and replace them with new ones if necessary.
z
Make sure the opener cable is connected securely.
z
Make sure the top of the trim overlaps with the headliner correctly (see AIR BAG RESTRAINT
SYSTEMS ).
z
Make sure the trim hooks are installed into holes in the side curtain airbag center bracket securely.
z
Push the clip portions into place securely.
z
Apply liquid thread lock to the front seat belt upper anchor bolt before installation.
z
Before installing the anchor bolts, make sure there are no twists or kinks in the belts.
Fig. 75: Removing & Installing Door Area Trim (With Side Curtain Airbag)
TRIM REMOVAL/INSTALLATION - REAR SHELF AREA
SRS components are located in this area. Review the SRS component locations and the precautions and
procedures in the SRS section before performing repairs or service. See AIR BAG RESTRAINT SYSTEMS .
Without Side Curtain Airbag
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст