Acura TSX / Honda Accord CL. Manual — part 781
Fig. 30: Removing The ATF Feed Pipes And ATF Joint Pipes
2. Remove the ATF strainer (C).
3. Remove the regulater valve body (D) (seven bolts).
4. Remove the stator shaft (E) and stator shaft stop (F), then remove the regulator separator plate (G) and
two dowel pins (H).
5. Remove the servo body (I) (11 bolts), then remove the separator plate (J) and two dowel pins (K).
6. Remove the cooler check valve spring (L) and valve (M), then remove the main valve body (N) (three
bolts). Do not let the check balls (O) fall out.
7. Remove the ATF pump driven gear shaft (P), then remove the ATF pump gears (Q).
8. Remove the main separator plate (R) and two dowel pins (S).
9. Remove the ATF magnet (T), clean and reinstall it in the torque converter housing (U).
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
10. Clean the inlet opening (A) of the ATF strainer (B) thoroughly with compressed air, then check that it is
in good condition and that the inlet opening is not clogged.
Fig. 31: Cleaning The Inlet Opening Of The ATF Strainer
11. Test the ATF strainer by pouring clean ATF through the inlet opening, and replace it if it is clogged or
damaged.
12. Remove the O-rings (V) (W) from the stator shaft and ATF strainer. Install the new ones when installing
the valve bodies.
VALVE BODY REPAIR
1. Soak a sheet of # 600 abrasive paper in ATF for about 30 minutes.
2. Carefully tap the valve body so the sticking valve drops out of its bore. It may be necessary to use a small
screwdriver to pry the valve free. Be careful not to scratch the bore with the screwdriver.
NOTE:
This repair is only necessary if one or more of the valves in a valve body do not
slide smoothly in their bores. Use this procedure to free the valves.
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
3. Inspect the valve for any scuff marks. Use the ATF-soaked # 600 paper to polish off any burrs that are on
the valve, then wash the valve in solvent and dry it with compressed air.
4. Roll up half a sheet of ATF-soaked # 600 paper and insert it in the valve bore of the sticking valve. Twist
the paper slightly, so that it unrolls and fits the bore tightly, then polish the bore by twisting the paper as
you push it in and out.
NOTE:
The valve body is aluminum and doesn't require much polishing to remove
any burrs.
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
Fig. 32: Polishing The Bore By Twisting The Paper As You Push It In And Out
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст