Acura TSX / Honda Accord CL. Manual — part 782
5. Remove the # 600 paper. Thoroughly wash the entire valve body in solvent, then dry it with compressed
air.
6. Coat the valve with ATF, then drop it into its bore. It should drop to the bottom of the bore under its own
weight. If not, repeat step 4, then retest. If the valve still sticks, replace the valve body.
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
Fig. 33: Drop The Valve Into Its Bore
7. Remove the valve, and thoroughly clean it and the valve body with solvent. Dry all parts with compressed
air, then reassemble using ATF as a lubricant.
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
VALVE BODY VALVE INSTALLATION
1. Coat all parts with ATF before assembly.
2. Install the valves and springs in the sequence shown for the main valve body (see MAIN VALVE BODY
DISASSEMBLY, INSPECTION, AND REASSEMBLY ), regulator valve body (see REGULATOR
VALVE BODY DISASSEMBLY, INSPECTION, AND REASSEMBLY ), and servo body (see
SERVO BODY DISASSEMBLY, INSPECTION AND REASSEMBLY ). Refer to the following
valve cap illustrations, and install each valve cap so the end shown facing up will be facing the outside of
the valve body.
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
Fig. 34: Valve Cap Illustrations
3. Install all the springs and seats. Insert the spring (A) in the valve, then install the valve in the valve body
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст