Acura CSX. Manual — part 28
*05
17
18
19
5-10
Engine Assembly
A
B
A
B
55. Remove the front subframe.
56. Lower the vehicle on the lift.
57. A/T model: Remove the transmission mount.
58. A/T model: Remove the ground cable (A), then
remove the transmission mount bracket (B).
59. A/T model: Install the transmission hanger bracket
(P/N 21232-RCT-A00) (A) and a washer (B) on the
transmission.
Replace.
Replace.
Replace.
Replace.
Replace.
04
*06
21
22
5-11
07AAK-SNAA120
B
07AAK-SNAA120
A
A/T model
C
M/T model
60. Install the universal lifting eyelet (07AAK-
SNAA120).
61. Attach a chain hoist (A) to the universal lifting
eyelet (B) and the transmission hook (C), then lift
the engine/transmission until it’s securely
supported by the chain hoist, and remove the
engine hanger.
62. Remove the side engine mount bracket mounting
bolt and nut.
63. M/T model: Remove the transmission mount
bracket mounting bolt and nuts.
Replace.
Replace.
5-12
Engine Assembly
64. Check that the engine/transmission is completely
free of vacuum hoses, fuel and coolant hoses, and
electrical wiring.
65. Slowly lower the engine/transmission about
150 mm (6 in.). Check once again that all hoses and
electrical wiring are disconnected and free from the
engine/transmission, then lower it all the way.
66. Disconnect the chain hoist from the engine/
transmission.
67. Raise the vehicle on the lift, then remove the
engine/transmission from under the vehicle.
#
@
01
SNR9A00A18223800000KCAT00
Special Tools Required
K20Z2 engine
5-13
Engine Installation
SIDE ENGINE MOUNT BRACKET
10 x 1.25 mm
44 N·m
(4.5 kgf·m, 33 lbf·ft)
LOWER TORQUE ROD BRACKET
A/C COMPRESSOR BRACKET
12 x 1.25 mm
74 N·m
(7.5 kgf·m, 54 lbf·ft)
10 x 1.25 mm
44 N·m
(4.5 kgf·m, 33 lbf·ft)
• Universal lifting eyelet 07AAK-SNAA120
• Engine hanger adapter VSB02C000015
• Engine support hanger, A and Reds AAR-T1256
• 2006 Civic engine hanger VSB02C000025
• Front subframe adapter VSB02C000016
: These special tools are available through Honda Canada Inc. Technical Tools Department; FAX
866-398-8665/
e-mail: ch_technicaltools
ch.honda.com
1. Install the engine mount brackets and the accessory brackets, then tighten their bolts to the specified torque.
Replace.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст