Acura CSX. Manual — part 428
01
02
03
SNR9A00J34300044021KBAT00
20-34
Mirrors
Mirror Holder Replacement
A
B
C
A
B
C
D
E
C
E
F
A
B
C
B
A
B
C
A
C
C
B
A
A
B
C
NO GOOD
OK
NOTE: Put on gloves to protect your hands.
1. Carefully push on the top edge of the mirror holder
(A) by hand.
2. Put a shop towel in the opening between the lower
edge of the mirror holder and the mirror housing
(B) to prevent scratches, and detach the bottom
clips (C) with a flat-tip screwdriver wrapped with
protective tape.
3. Carefully pull out the bottom edge of the mirror
holder (A) to separate the adhesive (B), and then
release the side clips (C).
4. Separate the mirror holder from the actuator (D) by
releasing the hooks (E). Disconnect the mirror
defogger connectors (F) from the heater pad
terminals.
5. Before reinstalling the mirror holder to the inner
holder (A) on the actuator, check the actuator rods
(B) and the actuator boots (C). Make sure the
actuator rods are securely mounted in the holes,
and that the boots properly cover each rod.
6. Reconnect the mirror defogger connectors.
7. Reattach the hooks of the mirror holder to the
actuator, then position the mirror holder on the
actuator. Carefully push on the clip portions of the
mirror holder until the mirror holder locks into
place.
8. Check the actuator operation.
08/08/21 15:00:05 61SNR030_200_0036
01
02
SNR9A00J34300034651KBAT00
20-35
Rearview Mirror Replacement
A
A
B
C
1. Turn the rearview mirror base (A) 90 °.
2. Slide the rearview mirror (A) down toward the
bottom of the windshield to detach it from the
spring (B) in the mount (C).
3. Install the rearview mirror in the reverse order of
removal.
08/08/21 15:00:05 61SNR030_200_0037
*01
*02
SNR9A00J54400000000DAAT00
20-36
Glass
Component Location Index
CLIP, 2
UPPER RUBBER DAM
WINDSHIELD
WINDSHIELD MOLDING
MOLDING UPPER SEAL
SIDE RUBBER DAM
LOWER RUBBER DAM
CLIP, 2
RUBBER DAM
FRONT CORNER GLASS
FRONT CORNER TRIM
CLIP, 2
Replacement, page 20-38
Replacement, page 20-43
08/08/21 15:00:06 61SNR030_200_0038
*03
20-37
UPPER RUBBER DAM
REAR WINDOW
CLIP, 2
(Self-adhesive-type, glass side)
SIDE RUBBER DAM, 2
LOWER RUBBER DAM
SIDE FASTENER, 2
(Self-adhesive-type, body side)
SIDE FASTENER, 2
(Self-adhesive-type,
glass side)
Replacement, page 20-47
08/08/21 15:00:07 61SNR030_200_0039
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст