Acura RSX Honda Integra. Manual — part 280
S6M6APPK77100091732FAAT00
−
−
−
−
−
−
−
−
−
−
DTC P1732:
2005-2006 Models
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
14-245
Problem in Shift Control System:
• Shift Solenoid Valves B or C Stuck ON
• Shift Valves B or C Stuck
NOTE: Record all freeze data and review General
Troubleshooting Information (see page 14-8) before
you troubleshoot.
1. Warm up the engine to normal operating
temperature (the radiator fan comes on).
2. Make sure that the transmission is filled to the
proper level, and check for fluid leaks.
3. Drain the ATF (see step 3 on page 14-272) through a
strainer. Inspect the strainer for metal debris or
excessive clutch material.
Replace the transmission.
Replace the ATF (see step 4 on page 14-272)
then go to step 4.
4. Clear the DTC with the HDS.
5. Test-drive the vehicle in the D position through all
five gears at speeds over 12 mph (20 km/h) for
more than 20 seconds, then slow down to a stop.
6. Retest-drive the vehicle in the D position through
all five gears at speeds over 12 mph (20 km/h) for
more than 20 seconds, then slow down to a stop.
7. Monitor the OBD status for P1732 in the DTCs/
Freeze Data in A/T Mode Menu for a pass/fail.
Go to step 8.
Intermittent failure, the system is OK at this
time. If the tester indicates NOT COMPLETED,
return to step 5 and recheck.
8. Clear the DTC with the HDS.
9. Choose Shift Solenoid B in Miscellaneous Test
Menu, and check that shift solenoid valve B
operates with the HDS.
Go to step 10.
Replace shift solenoid valve B (see page
14-260), then go to step 14.
10. Choose Shift Solenoid C in Miscellaneous Test
Menu, and check that the shift solenoid valve C
operates with the HDS.
Go to step 11.
Replace shift solenoid valve C (see page
14-260), then go to step 14.
11. Test-drive the vehicle in the D position through all
five gears at speeds over 12 mph (20 km/h) for
more than 20 seconds, then slow down to a stop.
12. Retest-drive the vehicle in the D position through
all five gears at speeds over 12 mph (20 km/h) for
more than 20 seconds, then slow down to a stop.
13. Monitor the OBD status for P1732 in the DTCs/
Freeze Data in A/T Mode Menu for a pass/fail.
Repair hydraulic system related with shift
valves B and C, or replace the transmission, then
go to step 14.
Intermittent failure, the system is OK at this
time. If the tester indicates NOT COMPLETED,
return to step 11 and recheck.
(cont’d)
Does the str ainer contain metal debr is or
excessive clutch mater ial?
Does the r esult indicate a f ailed?
Is a clicking sound hear d?
Is a clicking sound hear d?
Does the r esult indicate a f ailed?
05/06/27 17:57:14 61S6M040_140_0246
−
−
YES
NO
14-246
Automatic Transmission
DTC Troubleshooting (cont’d)
14. Clear the DTC with the HDS.
15. Test-drive the vehicle in the D position through all
five gears at speeds over 12 mph (20 km/h) for
more than 20 seconds, then slow down to a stop.
16. Retest-drive the vehicle in the D position through
all five gears at speeds over 12 mph (20 km/h) for
more than 20 seconds, then slow down to a stop.
17. Monitor the OBD status for P1732 in the DTCs/
Freeze Data in A/T Mode Menu for a pass/fail.
Troubleshooting is completed.
Return to step 8 and recheck.
Does the r esult indicate a passed?
05/06/27 17:57:14 61S6M040_140_0247
S6M6APPK77100091733FAAT00
−
−
−
−
−
−
−
−
−
−
DTC P1733:
2005-2006 Models
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
14-247
Problem in Shift Control System:
• Shift Solenoid Valve D Stuck ON
• Shift Valve D Stuck
• A/T Clutch Pressure Control Solenoid Valve C Stuck
OFF
NOTE: Record all freeze data and review General
Troubleshooting Information (see page 14-8) before
you troubleshoot.
1. Warm up the engine to normal operating
temperature (the radiator fan comes on).
2. Make sure that the transmission is filled to the
proper level, and check for fluid leaks.
3. Drain the ATF (see step 3 on page 14-272) through a
strainer. Inspect the strainer for metal debris or
excessive clutch material.
Replace the transmission.
Replace the ATF (see step 4 on page 14-272)
then go to step 4.
4. Clear the DTC with the HDS.
5. Test-drive the vehicle in the D position through all
five gears at speeds over 12 mph (20 km/h) for
more than 20 seconds, then slow down to a stop.
6. Retest-drive the vehicle in the D position through
all five gears at speeds over 12 mph (20 km/h) for
more than 20 seconds, then slow down to a stop.
7. Monitor the OBD status for P1733 in the DTCs/
Freeze Data in A/T Mode Menu for a pass/fail.
Go to step 8.
Intermittent failure, the system is OK at this
time. If the tester indicates NOT COMPLETED,
return to step 5 and recheck.
8. Clear the DTC with the HDS.
9. Choose Shift Solenoid D in Miscellaneous Test
Menu, and check that the shift solenoid valve D
operates with the HDS.
Go to step 10.
Replace shift solenoid valve D (see page
14-260), then go to step 15.
10. Choose Clutch Pressure Control (Linear) Solenoid C
in Miscellaneous Test Menu, and test the A/T clutch
pressure control solenoid valve C with the HDS.
Go to step 11.
Follow the instructions indicated on the HDS
by the tester result, but if the tester has not
determined the cause of the failure, go to step 14. If
any part was replaced, go to step 15.
11. Test-drive the vehicle in the D position through all
five gears at speeds over 12 mph (20 km/h) for
more than 20 seconds, then slow down to a stop.
12. Retest-drive the vehicle in the D position through
all five gears at speeds over 12 mph (20 km/h) for
more than 20 seconds, then slow down to a stop.
13. Monitor the OBD status for P1733 in the DTCs/
Freeze Data in A/T Mode Menu for a pass/fail.
Repair hydraulic system related with shift
valve D, or replace the transmission, then go to
step 15.
Intermittent failure, the system is OK at this
time. If the tester indicates NOT COMPLETED,
return to step 11 and recheck.
(cont’d)
Does the str ainer contain metal debr is or
excessive clutch mater ial?
Does the r esult indicate a f ailed?
Is a clicking sound hear d?
Is the system OK ?
Does the r esult indicate a f ailed?
05/06/27 17:57:14 61S6M040_140_0248
−
−
−
−
YES
NO
YES
NO
14-248
Automatic Transmission
DTC Troubleshooting (cont’d)
14. Inspect A/T clutch pressure control solenoid valve
C (see page 14-264).
Repair hydraulic system related with shift
valve D, or replace the transmission, then go to
step 15.
Replace A/T clutch pressure control solenoid
valve C (see page 14-265), then go to step 15.
15. Clear the DTC with the HDS.
16. Test-drive the vehicle in the D position through all
five gears at speeds over 12 mph (20 km/h) for
more than 20 seconds, then slow down to a stop.
17. Retest-drive the vehicle in the D position through
all five gears at speeds over 12 mph (20 km/h) for
more than 20 seconds, then slow down to a stop.
18. Monitor the OBD status for P1733 in the DTCs/
Freeze Data in A/T Mode Menu for a pass/fail.
Troubleshooting is completed.
Return to step 8 and recheck.
Does the A/ T clutch pr essur e contr ol solenoid
valve C wor k pr oper ly?
Does the r esult indicate a passed?
05/06/27 17:57:14 61S6M040_140_0249
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст