Acura RSX Honda Integra. Manual — part 375
01
09
01
20-36
Glass
Quarter Glass Replacement (cont’d)
: Apply body primer to exposed paint as shown.
16 mm
(0.63 in.)
16 mm
(0.63 in.)
16 mm
(0.63 in.)
16 mm
(0.63 in.)
1 mm
(0.43 in.)
4.5 mm
(0.17 in.)
2 mm
(0.08 in.)
4.5 mm
(0.17 in.)
13 mm (0.51 in.)
8 mm (0.31 in.)
A
13 mm
(0.51 in.)
8 mm
(0.31 in.)
2 mm
(0.08 in.)
A
A
B
B
B
B
A
Inside
Inside
A
Inside
5 mm
(0.2 in.)
27 mm
(1.1 in.)
5 mm
(0.2 in.)
A
A
A
13. With a sponge, carefully apply a light coat of body
primer to any exposed paint around the flange
where new adhesive will be applied. Let the primer
dry for at least 10 minutes:
• Do NOT apply body primer to any remaining
original adhesive on the flange.
• Be careful not to mix up the body and glass
primer sponges.
• Never touch the primed surface with your hands.
14. Cut a ‘‘V’’ in the end of the nozzle (A) on the
adhesive cartridge as shown.
15. Put the cartridge in a caulking gun, and run a bead
of adhesive (A) around the edge of the quarter
glass (B) as shown:
• After applying the adhesive, peel the separator
off the butyl tape.
• Apply the adhesive within 30 minutes after
applying the glass primer. Make a slightly thicker
bead at each corner.
05/06/27 18:22:29 61S6M040_200_0037
*11
20-37
A
B
C
16. Use suction cups (A) to hold the quarter glass (B)
over the opening, align the clips or the alignment
marks (C) made in step 10, and set it down on the
adhesive. Lightly push on the quarter glass until its
edges are fully seated on the adhesive all the way
around. Do not open or close the doors until the
adhesive is dry.
17. Scrape or wipe the excess adhesive off with a putty
knife or towel. To remove adhesive from a painted
surface or the quarter glass, wipe with a soft shop
towel dampened with alcohol.
18. Let the adhesive dry for at least 1 hour, then spray
water over the quarter glass and check for leaks.
Mark the leaking areas and let the quarter glass dry,
then seal with sealant. Let the vehicle stand for at
least 4 hours after quarter glass installation. If the
vehicle has to be used within the first 4 hours, it
must be driven slowly.
19. Reinstall all remaining removed parts.
NOTE: Advise the customer not to do the following
things for 2 to 3 days:
• Slam the doors with all the windows rolled up.
• Twist the body excessively (such as when going
in and out of driveways at an angle or driving
over rough, uneven roads).
05/06/27 18:22:29 61S6M040_200_0038
*02
S6M6A22J34200000000DAAT01
20-38
Moonroof
Component Location Index
GLASS
CABLE ASSEMBLY
DRAIN CHANNEL
DRAIN CHANNEL SEAL
ANCHOR SPRING
ANCHOR ROD
SUNSHADE
LIFTER
GLASS BRACKET
SLIDE STOPPER
LINK
SLIDER
FRONT DRAIN
CHANNEL
FRONT RAIL
HOLDER
GUIDE RAIL
FRAME SEAL
REAR DRAIN TUBE
FRAME
FRONT DRAIN TUBE
FRONT DRAIN VALVE
REAR DRAIN VALVE
MOTOR
Glass Height Adjustment, page 20-40
Replacement, page 20-40
Closing Force and Opening Drag
Check, page 20-48
Replacement, page 20-45
Replacement, page 20-41
Replacement, page 20-43
Replacement, page 20-43
Replacement, page 20-43
Replacement, page 20-42
05/06/27 18:22:31 61S6M040_200_0039
S6M6A22J34200000000HBAT01
Symptom
Diagnostic procedure
Also check for
20-39
Symptom Troubleshooting Index
Water leaks from
moonroof
1.
2.
3.
4.
Check for a clogged drain tube.
Check for a gap between the glass weatherstrip and the roof
panel.
Check for a defective or an improperly installed glass
weatherstrip or drain channel.
Check for a gap between the drain seal and the roof panel.
Wind noise from
moonroof
Check for excessive clearance between the glass weatherstrip and
the roof panel.
Motor noise from
moonroof
1.
2.
3.
Check for a loose motor.
Check for a worn gear or bearing.
Check for a deformed cable assembly.
Glass does not move,
but motor turns
1.
2.
3.
4.
Check for a defective gear or inner cable.
Check for foreign material stuck between the guide rail and
the slider.
Check for a loose inner cable.
Make sure the cable assembly is attached properly.
Glass does not move
and motor does not
turn (glass can be
moved with
moonroof wrench)
1.
2.
3.
4.
5.
Check for a blown fuse.
Check for a faulty moonroof switch.
Check for a run down battery.
Check for a defective motor.
Check for a faulty relay.
05/06/27 18:22:31 61S6M040_200_0040
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст