DAF 95XF. Manual — part 566
8
TECHNICAL DATA
Tandem rear axle 1355 T
95XF series
3-4
0
200424
0
8
95XF series
Trailing axles
TECHNICAL DATA
4-1
4. TRAILING AXLES
4.1 GENERAL
Wheel bearings
Wheel bearing play
0.025 - 0.25 mm
Hub cap
Sealant
Loctite 572
4.2 TIGHTENING TORQUES
The tightening torques stated in this section are
different from the standard tightening torques
stated in the overview of the standard tightening
torques. Any other threaded connections that
are not specified must therefore be tightened to
the torque stated in the overview of standard
tightening torques.
When attachment bolts and nuts are replaced, it
is important that - unless stated otherwise -
these bolts and nuts are of exactly the same
length and property class as the ones removed.
Hub of trailing axle 09N075
Hub lock nut, 09N075
210 Nm
Wheel nuts
700 Nm
(1)
Hub of trailing axle 09N220
Hub lock nut, 09N220
560 Nm
Hub cap attachment bolts
70 Nm
Wheel nuts
700 Nm
(1)
200424
8
TECHNICAL DATA
Trailing axles
95XF series
4-2
Bearing block
A
Attachment bolts, bearing block to
bearing support
-
if M16 8.8 nut
195 Nm
-
if M16 10.9 nut
260 Nm
B
Pull-rod/push-rod
attachment nut
130 Nm
C
Adjusting nut, outer bearing
block
90 Nm
A8 00 346
A
Note:
(1)
Retighten after 100 km; if new wheel nuts have been
fitted, the wheels need additional retightening after
500 km.
0
200424
0
8
95XF series
Hydraulic lifting gear
TECHNICAL DATA
5-1
5. HYDRAULIC LIFTING GEAR
5.1 GENERAL
Cut-out pressure, pressure switch
160 bar
Pre-set value, pressure relief valve
180 bar
Maximum admissible system pressure
200 bar
Test pressure, lifting cylinder
220 bar
Delivery pipe while lifting
Line connection B
Delivery pipe while lowering
Line connection A
(The characters are printed on the pump unit)
Safety device
Once the trailing axle has been lowered, it can
only be lifted again after approx. 2.5 minutes.
If the control switch is put into the “lifting”
position within approx. 2.5 minutes, the lifting
gear will not be activated and the time relay
will be reset. In that case you will have to wait
about another 2.5 minutes before the trailing
axle can be lifted.
5.2 TIGHTENING TORQUES
The tightening torques stated in this section are
different from the standard tightening torques
stated in the overview of the standard tightening
torques. Any other threaded connections that
are not specified must therefore be tightened to
the torque stated in the overview of standard
tightening torques.
When attachment bolts and nuts are replaced, it
is important that - unless stated otherwise -
these bolts and nuts are of exactly the same
length and property class as the ones removed.
Pump unit
2/2 valve
25 Nm
4/2 valve
25 Nm
Pressure relief valve
30 Nm
Pressure switch
25 Nm
Pump attachment bolts
25 Nm
Engine attachment bolts
17 Nm
Cylinder
Piston attachment nut
200 Nm
200424
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст