Honda Ridgeline. Manual — part 270
01
02
03
04
SJC8A00E16226600000LCAT00
Special Tools Required
Locking tab type
Double loop type
Inboard Joint Side
16-6
Driveline/Axle
Front Driveshaft Disassembly
A
B
D
C
E
A
A
D
C
B
• Threaded adapter, 26 x 1.5 mm 07XAC-001030A
• Slide hammer, 5/8’’ x 18 UNF, commercially available
1. Remove the set ring from the inboard joint (left
driveshaft).
2. Remove the boot bands. Be careful not to damage
the boot.
• If the boot band is a locking tab type (A), pry up
the locking tab (B) with a screwdriver, and lift up
the end of the band.
• If the boot band is a double loop type (C), lift up
the band end (D), and push it into the clip (E).
3. Make a mark (A) on each roller (B) and inboard joint
(C) to identify the locations of rollers and grooves
in the inboard joint. Then remove the inboard joint
on the shop towel (D). Be careful not to drop the
rollers when separating them from the inboard
joint.
05
06
07
Double loop type
Locking tab type
16-7
A
C
D
B
E
A
A
B
4. Make a mark (A) on the rollers (B) and spider (C) to
identify the locations of the rollers on the spider,
then remove the rollers.
5. Remove the snap ring (D).
6. Mark the spider and driveshaft (E) to identify the
position of the spider on the shaft.
7. Remove the spider.
8. Wrap the splines on the driveshaft with vinyl tape
(A) to prevent damage to the boot.
9. Remove the inboard boot and boot band (B). Be
careful not to damage the boot.
10. Remove the vinyl tape.
(cont’d)
08
09
10
11
Outboard Joint Side
16-8
Driveline/Axle
Front Driveshaft Disassembly (cont’d)
A
B
A
B
A
C
07XAC-001030A
B
A
1. Remove the boot bands (A). Lift up the three tabs
(B) with a screwdriver. Be careful not to damage
the boot.
2. Slide the outboard boot (A) partially to the inboard
joint side. Be careful not to damage the boot.
3. Wipe off the grease to expose the driveshaft and
the outboard joint inner race.
4. Make a mark (A) on the driveshaft (B) at the same
position of the outboard joint end (C).
5. Carefully clamp the driveshaft in a vise.
6. Remove the outboard joint (A) using the special
tool and a commercially available 5/8’’ x 18 UNF
slide hammer (B).
12
13
16-9
A
7. Remove the driveshaft from the vise.
8. Remove the circlip from the driveshaft.
9. Wrap the splines on the driveshaft with vinyl tape
(A) to prevent damage to the boot.
10. Remove the outboard boot. Be careful not to
damage the boot.
11. Remove the vinyl tape.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст