Mitsubishi Outlander (2003+). Manual — part 327
REAR BUMPER ASSEMBLY
EXTERIOR
51-7
REMOVAL SERVICE POINT
<<A>> CLIPS REMOVAL
Remove the clip with a pair of pliers by removing the
claw of the clip from the cabin side.
AC200942
Section A – A
Clip
Claw
Claw
A
A
AB
Plier
Quarter trim lower
REAR BUMPER ASSEMBLY
EXTERIOR
51-8
DISASSEMBLY AND REASSEMBLY
M1511002100338
AC300244
6
5
4
3
3
9
7
10
1
8
2
N
N
AB
Disassembly steps
1. Side cover
2. Muffler cover
<<A>> >>A<<
3. Rivets
4. Rear bumper side plate
5. Rear bumper harness
6. Rear bumper reinforcement
7. Licence plate lamp assembly
8. Reflector
9. Licence plate bracket
10. Rear bumper face
Disassembly steps (Continued)
REAR BUMPER ASSEMBLY
EXTERIOR
51-9
DISASSEMBLY SERVICE POINT
<<A>> RIVETS REMOVAL
Use a drill (
φ
4.0 mm) to make a hole in the rivet to
break it, and then remove the rivet.
REASSEMBLY SERVICE POINT
>>A<< RIVETS INSTALLATION
Use recommended tool shown in the illustration to
connect the rivet by the following procedure.
1. Insert the rivet into the base material (rear bumper
face, rear bumper side plate).
2. Place the recommended tool over section A of
rivet.
3. While pushing the flange surface of the rivet with
the recommended tool, press the handle of the
tool.
4. The thin part of section A of the rivet will break
and the rivet will then be attached.
AC100411AB
Rivet
Drill
Bumper face
Y0412AU
AC005876
18E0192
AB
1
2
3
4
Section A
Rivet
Flange
Rivet
Rear bumper
side plate
Rear bumper
face
Rear bumper face
Recommended tool
Recommended
tool
RADIATOR GRILLE
EXTERIOR
51-10
RADIATOR GRILLE
REMOVAL AND INSTALLATION
M1511002900301
AC200008
2
1
2
1
2
2
2
1
Front bumper
assembly
Front bumper
assembly
Clip
Headlight
Clip
Section C – C
Section B – B
Section A – A
AC200008
A
B
B
C
C
AB
A
Removal steps
<<A>>
1. Clips
>>A<<
2. Radiator grilles
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст