Mitsubishi Outlander (2003+). Manual — part 572
SENSORS
AUTOMATIC AIR CONDITIONER
55B-103
SENSORS
REMOVAL AND INSTALLATION
M1554001900099
AC301526AB
1
2
3
Interior temperature sensor
removal steps
•
Instrument lower panel (Refer to
GROUP 52A, Instrument Panel
<LHD>
or Instrument
Panel <RHD>
1.
Interior temperature sensor
Heater water temperature sensor
removal steps
•
Foot duct <front passenger's side>
(Refer to GROUP 55A, Ventilator
2.
Heater water temperature sensor
Photo sensor removal steps
•
Instrument lower panel (Refer to
GROUP 52A, Instrument Panel
<LHD>
or Instrument
Panel <RHD>
<<A>>
>>A<<
3.
Photo sensor
SENSORS
AUTOMATIC AIR CONDITIONER
55B-104
REMOVAL SERVICE POINTS
<<A>> PHOTO SENSOR REMOVAL
Binding the photo sensor connector with a cord and
rapping a tape around the connector as its surface is
flatly to pull out the photo sensor toward the
instrument panel upper.
INSTALLATION SERVICE POINTS
>>A<< PHOTO SENSOR INSTALLATION
Tape the photo sensor under the defroster nozzle.
INSPECTION
M1552014300767
INTERIOR TEMPERATURE SENSOR
CHECK
Check to see that the resistance shown in the graph
is almost satisfied when measuring the resistance
between the terminals under two or more different
temperature conditions.
HEATER WATER TEMPERATURE
SENSOR CHECK
Check to see that the resistance shown in the graph
is almost satisfied when measuring the resistance
between the terminals under two or more different
temperature conditions.
PHOTO SENSOR CHECK
Check that the blower rotation comes down if the
photo sensor is covered with hands, when the
automatic A/C is operating (in summer sunbeam). If
not the rotation comes down, replace the photo
sensor.
AC301536
String
AB
Tape
AC301539
AB
Defroster nozzle
Tape
Photo sensor
harness
AC103488
20
15
10
5
0
-10 0
20
40
60
80
AB
Resis
tance
(k
Ω
)
Temperature (˚C)
AC103488
20
15
10
5
0
-10 0
20
40
60
80
AB
Resis
tance
(k
Ω
)
Temperature (˚C)
EVAPORATOR ASSEMBLY
AUTOMATIC AIR CONDITIONER
55B-105
EVAPORATOR ASSEMBLY
REMOVAL AND INSTALLATION
M1552003600195
Refer to GROUP 55A, Evaporator assembly
INSPECTION
M1552014300734
AIR THERMO SENSOR CHECK
Check to see that the resistance shown in the graph
is almost satisfied when measuring the resistance
between the terminals under two or more different
temperature conditions.
NOTE: The temperature should be within the shown
range.
AMBIENT TEMPERATURE SENSOR
INSPECTION
M1552014300745
Check to see that the resistance shown in the graph
is almost satisfied when measuring the resistance
between the sensor terminals under two or more
different temperature conditions.
AC103661
25
20
15
10
5
0
-10
0
10
20 30 40
AB
Resistance
(k
Ω
)
Temperature (˚C)
AC301106
Ambient air temperature sensor
AC
AC103489AB
50
40
30
20
10
0
-30 -20
0
20
40 60
Resistance
(k
Ω
)
Temperature (˚C)
OTHER PARTS
AUTOMATIC AIR CONDITIONER
55B-106
OTHER PARTS
OTHER PARTS
M1554004000073
The following maintenance service points are the
same as for the manual A/C.
Item
Reference
page
On-vehicle
service
Refrigerant level test
Magnetic clutch test
Compressor drive
belt adjustment
A/C pressure sensor
simple check
Charging
Correcting low
refrigerant level in
case the service can
in used
Discharging system
Refilling of oil in the
A/C system
Performance test
Refrigerant leak
repair procedure
Compressor noise
check
Power relay
continuity check
Idle-up operation
check
Clean air filter
replacement
procedure
Heater unit and blower assembly
Blower motor and outside/inside
air selection damper control motor
Evaporator and air thermo sensor
A/C compressor
Condenser and condenser fan
motor
Refrigerant line
Ventilators
Item
Reference
page
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст